|08-30-2013 03:16 PM|
210 is normal and it shouldn't be much more than a needle width either direction.
Did the white smoke dissapate??
Did some air bubbles come out and can you see the water flowing???
|08-30-2013 02:55 PM|
|08-21-2013 12:34 PM|
Burp the air and make sure you have water flowing.
Your white smoke did it last long or disapate with time. Could have dirty hand prints.
Watch the temp gauge keep a hose handy and if you get a unexpected overheat check flow in the radiator. Only use the hose to fill and spray the front of the radiator no where else.
Mine smoked a bit after overhaul and spiked the temp right away but once it burped the air bubble and I added water it settled right down.
All the oily residue burnt off on 5 minutes.
|08-21-2013 11:56 AM|
Thanks for the replies guys. So I'm going to run it again today. And old buddy of mine said to let it run for about 20 - 30 mins. I'll try to get some pictures in. Also, leaving the radiator cap open to see if there is any splashing- I'll do this too, but what is the significance?
|08-19-2013 06:47 PM|
|173ABN VN||check your oil,if it's white could be a problem....russ|
|08-19-2013 03:20 PM|
Did the amount of white smoke deminish after you had the engine running for a bit ??
The cast iron exhaust manifild is porous and will hold oil and coolant for a considerable time. If it did not, check the intake gasket for leaks, if you didn't get all of the clag off the mating surfaces, it will leak.
|08-19-2013 02:46 PM|
|ddtt225||I'd go with what Saharagreen says. It does sound like the gasket might be pinched and is allowing coolant to seep.|
|08-19-2013 02:04 PM|
Ok so you can pull the radiator cap and crank her up if you made a mistake with the headgasket or if the gasket got damaged while you installed it will blow coolant out pretty quickly. That way you know pretty quickly if the head gasket is still the issue.
However a little white smoke is to be expected after this install even if done correctly.
Lastly monitor your temp gauge it will overheat fast if the issue is still the head gasket.
Also did you take pictures of this work so you can share with the rest of the forum?
Guaranteed someone somewhere is thinking about this right now on the forum so share your experience.
|08-19-2013 01:43 PM|
Need some help! Post-head gasket replacement!
New to the forums here. Just wanted to say thanks to everyone who post here because I would not have come this far without you guys.
My baby: 1995 2.5l Rio Grande
So, I just recently replaced my head gasket and I followed the protocols of the Haynes manual, along with some help of one of my friends- P.S. this was my first experience repairing my jeep and the learning curve was steep for me.
I had a blown head gasket. I replaced the head gasket, got the head machined- no cracks/warps, and I've changed the oil, and coolant.
THE PROBLEM(?): Turned on the car today for the first time since I replaced everything. Sounds perfect, started perfect, but I'm getting white smoke from around the exhaust manifold, I'm assuming its around the head pipe or something, but its not much smoke at all. It doesn't smell like oil, but I can't tell. I'm aware this could be coolant in the exhaust and I just need the car to run, but I shut the car off after 5 minutes because the smoke was concerning me. What should I do?