|08-05-2009 06:47 PM|
hey all. I got it fixed. couldn't wait it out, just had to get it done. first went and bought a used knuckle from the junkyard for back up, which looked like crap. (rusted all over and just ugly compared to mine) put her back up on stands and got the damn bolt out with minor thread loss. (only loss was at the very end of the hole and on one side) so saved me some money and only took 20mins when i had it up. i'll take a little manual labor over 1-2hrs at a shop.
Thanks to all for the input!
|08-04-2009 08:49 PM|
|kdukes4||probably grab some sort of pick too and try to break the very thin lining of the bolt and thread. if i end up messing it up, i'll go with the kit|
|08-04-2009 08:29 PM|
|kdukes4||interesting jerry... i got into it a little today and wimped out. got the pilot screw through, then tried the extractor, but the thing busted in half when i started to turn it hard. i think it was too small. I started to drill one size up a few times in a row and then stopped myself when i noticed that the hole wasn't straight. i'll try again a little later this week, ge the hole straightened and use a larger extractor. its not worth wasting time and effort to bring it into the shop and then be told that they cant weld it off, so i'm back where i started.|
|08-04-2009 07:08 PM|
|08-04-2009 03:28 PM|
thanks to all!
|08-04-2009 03:25 PM|
|08-04-2009 03:23 PM|
|08-04-2009 12:45 PM|
Do you have a welder? you could weld a bolt to it, or socket and get it out that way.. thats what i would do
|08-04-2009 11:30 AM|
|4Jeepn||so the head of the bolt broke off? Can you just remove the other bolt, rotate the caliper up and use a needle nose to turn the shaft? Or can you get enough room to cut it off, and leave enough shaft to turn it that way?|
|08-04-2009 10:12 AM|
|08-03-2009 09:56 PM|
|Jeeper2||Worst case got to Farm and Fleet and get a new Caliber, They are pretty cheap for new Calibers, If not Farm and fleet check another auto parts store. Save you time and headaches.|
|08-03-2009 04:42 PM|
|Jerry Bransford||It probably snapped by being overtorqued which also has a nasty habit of stripping out the threads in the knuckle. Keep in mind that those particular bolts are only tightened to 11 ft-lbs. If it all goes to hell in a handbasket and the threads get boogered up, a friend of mine who is a Jeep parts designer makes a thread repair kit for that exact bolt hole in the caliper. He sells it on his wife's Amazon.com website.|
|08-03-2009 04:17 PM|
|kdukes4||got the answer: Screw/Bolt Extractor. let's see how it goes.|
|08-03-2009 03:36 PM|
|kdukes4||i dont have access to a welder, so you can throw the nut and heat idea out the window.|
|08-03-2009 02:47 PM|
broken bolt in caliper
hey all. my caliper has an issue. a couple days ago, the bottom bolt of the caliper just snapped off. i didn't notice it untill it started to squeek on the turns. when i gave it a better look, the end of the bolt is still threaded into the caliper. how can i get that out? i stopped by a shop and i was told 1-2 hrs of labor to get it out. Bulls@$t. there must be a way?