|09-07-2009 03:13 PM|
|Jeeper2||If you have a lift check the bushings on the lift. I know someone who had the same problem. we put new bushing in the lower control arms and it was like new.|
|09-06-2009 11:22 PM|
|AzTJ||Check your control arms as well. If the bushings are bad it can allow axle play as well. Just remove one end at a time and inspect.|
|09-06-2009 01:20 PM|
|09-06-2009 01:18 PM|
|DKarge87||This clunk could also be caused by worn sway bar links aswell|
|09-06-2009 10:52 AM|
|rabunjeeper||Mine was doing the exact same thing and it was the rear track bar where it bolts to axle. The bolt hole was egg shaped letting the rear move side to side. I just drilled it out and put a larger bolt in it.|
|09-05-2009 09:46 PM|
|Steviej35||Look at the rear trac bar see if there is any play there. Only other thing I can think of is to also open the rear axle and check the spider gears|
|09-05-2009 09:41 PM|
2001 TJ Clunk....advice please
I've got a 2001 Wrangler, 4.0 Auto, When I take off from a stop Im getting a harsh clunking noise, I thought from the front, but when outside the jeep it sounds like the rear. Also does it if I move forward a little bit then put it into reverse it clunks once.
I thought U-joints so I put new ones in but it still does it.
I took it on the highway and got up to about 50 mph, let off the gas then apply it again and it clunks, then feels like the whole jeep shifts sideways a little bit.
Im lost on where to look now, any help would be wonderful.