|09-07-2009 08:08 AM|
I used the synthetic fiber to stuff up behind the speakers and it worked well for the past 4 years. You can buy this at any crafts store for a few bucks a bag.
|08-28-2009 09:46 AM|
A dremel would be nice to have. Loaned mine out about 8 years ago, still waiting for it to come home.
I was under the impression that the company who made them (adapters) were no longer in business. I also figured it'd be pretty fun (and cheaper) to make my own. I didn't take (couldn't) any measurements for the spacers. I need to get the speaker holes drilled, and then a mock-up with speakers and side covers to check for clearance...and then play around with different size spacers.
|08-27-2009 03:22 PM|
|G-Pur||dremel baby, dremell!|
|08-27-2009 01:14 PM|
|AdvanZ33||I forked out the $20+ for the adapters. The spacers are a good idea though, I wonder how much clearance there is to work with...|
|08-15-2009 10:41 AM|
Also, I had noticed that while I had the speakers out, a great deal of sound was lost to the way they had the speakers angled.
I was thinking of fabbing up some 1/4"-1/2" spacers for the bottom part of the bracket to re-angle the speakers from my shins, to at least be aiming at my knees...lol.
Sounds corny, but even that little bit helps (or at least should).
|08-15-2009 10:19 AM|
Speaker adapter plate...advise needed
The other day I went to my local hardware store and purchased a small sheet of 22 guage steel (12"x18"...$4).
With this, I made my own adapter plates for the front dash, took about an hour and a half total time. Everything mounts up just fine....except, I don't have a 4 1/2" hole saw, and don't plan on buying one ($30+).
So my dilema is, now I have perfect adapter blanks and no way to cut the hole for the actual speakers. I was thinking about tracing out the circle, drilling holes on the trace line, then following through with a hack saw blade.
Any ideas to make this any easier?