|09-15-2009 05:26 PM|
|woods453||I might be wrong, but I'm pretty sure they ground inside the light housing. I would try to swap the 2 lightbulbs that are in the tail light. If the alarm guy took them out and put them back in the wrong sockets, it screws up everything because those bulbs are not the same.|
|09-15-2009 05:09 PM|
Turn Signal Grounding issue?
Well, I had an alarm installed on my jeep and now things are sort of screwy. I'm still trying to get ahold of the guy who installed the alarm system, but no luck... so hopefully someone here can help me out.
All my turn signals work fine when I first start up the vehicle, except for my driver's side rear light. It is very dim, especially when i'm using my break + left turn signal. However, as I drive the turn signal rate sometimes speeds up 2x as fast. When it speeds up like this, it actually effects both my left and rear turn signals. Additionally, sometimes both turn signals / brake lights cut out completely.
All my fuses are intact, and since the turn signal problems are sporadic, I doubt it's my brake or turn signal relays.
All clue's lead to some type of grounding issue but finding it has been a problem. Every ground I've come across is clean and tight.
Does anyone know where the tail light grounds are located? Do they return from the tail light back up to the front cab and ground somewhere up there?
Help is much appreciated
2006 Wrangler Sport