Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Control arm bushing!

Join Wrangler Forum Today


Thread: Control arm bushing! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-13-2009 08:01 PM
Jerry Bransford The bushings in the OE control arms are a royal PITA to remove, they're not like a bushing in a trackbar etc. which aren't too hard to remove/replace. When my old 4WP shop had to remove one, they seemed to need to use a torch on it to get it out.
10-13-2009 07:56 PM
Rawkon oooo im thinking the bushing in the axle housing. not at the frame end.
10-13-2009 10:48 AM
nicolas-eric If shipping from Germany to the US wouldn´t be that expensive you could have a CA with good bushings for free. I still have the stock CAs from 2 TJs and 1 ZJ in my garage.
10-13-2009 10:40 AM
Ironman I would also do it at home. I happen to have a press, but a vice does work fine. One method I use to align the bolt holes for the control arms is to jack the pumkin up in either the front or back to tilt it in the direction you need it to go. If you do one arm at a time, the hole shouldn't be that far off.
10-13-2009 10:31 AM
nicolas-eric You can press it out with a bench wise. On one side of the CA you put a nut that's smaller than the bushing and on the other side you put a nut that's bigger than the bushing.
It only takes some minutes.

And yes you can remove one CA when the Jeep is on ground. When the holes in the CA mount and in the CA are a bit off you can fix that with a lashing strap.
10-13-2009 10:07 AM
Rawkon they are a royal pain in the ass. a friend of mine just did it to his XJ. take it to a shop with the correct press to get the old busings out and new ones in.
10-13-2009 08:08 AM
SurfNaked2010
Control arm bushing!

on my 2000 tj my dana 30 top control arm bushing broke and is making a loud clank every time i make a turn or accelerate. can i just change it out while its flat on the ground and just unbolt the upper arm? or is there more required?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:59 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC