Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Crank Position Sensor Compatibility

Join Wrangler Forum Today

Thread: Crank Position Sensor Compatibility Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-26-2009 06:51 PM
vintageagain thanks for the reply guys. Finally did the swap and there was a CLEAR difference in flywheels and sensors. Since i was keeping the 95 computer i just swapped all that stuff over. Works great!
07-24-2009 09:40 PM
jpdocdave you're better off if the fly wheel and bell housing are different. the best way to do this is keep everything in the 95 that is in there now, other than the bad parts. might wanna think about a new clutch now to.

oh yeah, welcome to the forum.
07-24-2009 09:34 PM
vintageagain agreed, i'm trying to update the engine and everything to 95, just trying to find the easiest way.

i see the flywheel is different too. I was really trying not to detach the tranny.
07-24-2009 09:30 PM
jpdocdave you're way better off keeping the original engine management and fuel injection. swap the manifold off your 95 thats no good, and put it on the 89 motor. its been a while since i looked at the cps on those motors, but just do whatever you have to do to use the 95 sensor and harness. swap bellhousing or whatever.

i strongly advise not hacking your wiring, and/or installing tbi in your 95.
07-24-2009 09:26 PM
Crank Position Sensor Compatibility

So i'm in the middle of putting a 89 2.5 (w/MPI swap) in my 95 yj. The motor was shot so i bought another jeep with a poor body and am swaping the drive train. Through my research i have found the crank position sensor for the 1989 is different from the 1995. Any suggestions on how to handle this?

Can i just cut the connector and replace with the 89 connector? Can i just swap out the sensor and not worry about the flywheel?

for simplicity i'm trying to swap the n231 ax5 and 2.5 as an entire unit from one vehicle to the other.

thanks for the help

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 12:36 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC