|09-21-2013 09:33 PM|
|NateDawgF22||Sweet, I'll give it a shot! Thanks!|
|09-21-2013 08:03 PM|
|09-21-2013 07:59 PM|
|NateDawgF22||Alright, finally got done with the swap and thought I had it all right... Ran the jeep a little bit and heard a tiny pop every so often. Then a big pop. Lower hose popped right off. Should I have to bleed the air bubbles when I initially fill up the new radiator? I couldn't find any clear instructions on how to refill, but I did have the front end of the jeep slightly lifted when I put new coolant in. Would lifting the font end while putting coolant in be enough, or should I try and run it with the rad cap off to let the air out maybe?|
|09-21-2013 10:19 AM|
|09-21-2013 10:15 AM|
I just swapped my radiator last weekend and did the water pump this summer. The radiator is easier, except the last two (out of six) bottom
Bolts are hard to get to. You may only have to loosen these, as they do not have to be removed from the body to pull the radiator free.
To check your water pump, get under the car and look up at the pump and surrounding area. See if there is coolant dripping or if there are dried coolant stains, it's a good indicator. Water pumps will leak from their weep hole when going bad.
|09-21-2013 09:50 AM|
|NateDawgF22||Thanks for the help! Do you know a good way to test the water pump? I would hate to do all this work and that happen!|
|09-21-2013 08:32 AM|
|Medixtj01||How do you know if there you have a bad water pump|
|09-20-2013 09:53 PM|
If your engine overheated rapidly and the top of your radiator cracked... you may have a water pump problem or other coolant system blockage.
Several years ago my water pump failed suddenly while on a mtn pass at 60mph. The water pressure blew the entire top off of my radiator, oh yes it was quite the sight.
Not necessarily what your problem is, but don't rule it out. Something had to cause that crack on the top of your radiator. Either trauma, factory defect, or excessive pressure.
|09-20-2013 09:43 PM|
It is a super easy swap and no special tools are required... pretty self-explanatory process. Start by removing the fan shroud and the rest of the bolts and hoses are obvious. No need to remove the fan. If your Jeep is an automatic you'll need to remove the transmission cooling lines from the bottom of the radiator and plug them while you swap, they're easy too.
I replaced my radiator with an inexpensive CarQuest brand which is almost identical to OEM and it does fine. I think it was somewhere around $100 or more with a lifetime warranty. It's been in for 3 or 4 years now.
|09-20-2013 06:15 PM|
I have a 2002 Wrangler Sport. Just had my fan clutch replaced a year ago for overheating problems. Today, jeep overheated real quick, shut her off and theres a crack in the top of the radiator spewing out steam. Time to replace that thing. Any links to good how tos? Any recommendations for radiator brands? Is this a relatively easy fix to do on my own?