Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Best place to install amplifier power cable ???

Join Wrangler Forum Today


Thread: Best place to install amplifier power cable ??? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-01-2009 10:02 AM
Ej132 had the installer put it under the rear seat, wish it wasnt bolted down though
10-31-2009 10:16 PM
JAFOofNJ What I did and it was the same place I ran my original cb antenna wire. There is a rubber plug in the center of the firewall I just took a small notch in it and it comes out in the middle of the jeep from side to side. You may see it better from under the jeep or if you look on the other side of the brake booster from up top. On the inside its about 6 inches maybe from the hump of the trans there there is that gap between the foot wells below the dash. and I ran my cable under the center console and came out in the rear. I took my back seat out to feed my twin 1000 watt amps kickin my two 12's on a lil homemade rack that I have my box sitting on with the amps and my capacitor below my speakers. I do have my rca and remote wires running along my power wire (2ga.) and I have no troubles with my audio quality.

When I get back to the body shop ill take a few pictures if you want.
10-31-2009 08:33 AM
SPDNJOE BBNATE, did you recently nuy that jeep in Phoenix. It looks very familiar.
10-31-2009 08:21 AM
catITguy I drilled a small hole in the firewall on the drivers side. My amp is mounted behind/under the drivers seat. The reason I didnt go for the passenger side is I read that running the power cable right next to the RCA cables can cause interference. No complaints to date, it has been installed for a few months now and I couldnt be happier with it.
10-31-2009 08:08 AM
bbnate
Best place to install amplifier power cable ???

I have a 2001 Jeep Wrangler 4.0 and I'm trying to install my new amp with some new speakers. I'm just not sure if I should drill on the passenger side or run it across to the driver side. The amp will probable go some where in the back. Any suggestions??

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:39 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC