|12-22-2014 10:16 AM|
I'm thinking about getting the thule setup... anybody else have this???
|06-29-2014 08:42 PM|
I have a Yakima and rails that bolt straight to hard top. It works great and removes in minutes for when you don't need it. (Better mpg less wind resistance) it's in my profile pic. I'll show you the inside. It's well mounted. Top is hanging for the summer. It has carried a lot. No need to go to roll bar. This is designed well. I also made u shaped bars from galvanized pipe to lower it
For wind resistance and I can fit in the garage.
|06-29-2014 08:30 PM|
|johninsd||I also have the Body Armor rack and like it. It was a struggle to install but now that it's on there it's quite solid. The Thule 450 Crossroad feet work with it to attach Thule crossbars. I think they're bit less expensive and a bit lower profile than the Body Armor adapters.|
|06-29-2014 03:07 PM|
|nmarchiselli||My dad has the body armor safari rack on his 4 door wrangler and its awesome. hardtop and soft top both go on/off easy with the rack. I plan on getting the same for my TJ|
|06-29-2014 02:53 PM|
I also have the garvin wilderness rack. It is sturdy but there are a couple of cons to it.
1. Wish it had some quick disconnect pins so I didn't have to have tools to unbolt the front two and back two that are necessary to tilt it backwards. I could probably fashion something up but my friends top has this feature included, just can't remember what brand he has.
2. Where it attaches to the jeep in the front makes it a little difficult to remove my doors. I could probably shave off a little metal on the brackets to clear the door hinges but it really isn't that bad, just have to come at the right angle when taking them off or putting them back on.
3. The front off the rack prevents me from lifting the front of the softop straight up. It will hit the brackets so I had to slide the top on from back to front and can't use my sunrider feature. This doesn't really bother me because I live in Texas and the sun is just too strong most of the year so I like to be shaded by the top. It never gets removed and I don't use the sunrider feature.
All of these things are really no big deal. The pros out weight the cons. It is a very sturdy rack. It doesn't squeak or make any noise. It also looks really good. have seem some that just kind of look weird because they come out away from the jeep more so than this one.
It allows me to haul a lot more stuff when I go surf fishing and provides a nice place to attach a sun shade. It came on the jeep when I bought it but I would have probably bought the exact one if it didn't. It is really that good and I love it.
|06-29-2014 08:12 AM|
|IndianaBones||I love my body armor roof rack. I recommend it highly. Just make sure you wire any lights as you assemble the roof rack base, very difficult to go back and wire them once its all on.|
|06-28-2014 07:27 PM|
Without the Rack.
|06-28-2014 07:25 PM|
I have the Kargo Master Congo Cage with a safari rack. Very strong and works with hard, soft and no top. I take the rack off when I don't need it. They say it can hold 500# I believe it can.
|06-28-2014 12:19 PM|
|10-11-2013 10:22 AM|
|10-11-2013 09:51 AM|
|10-11-2013 09:15 AM|
|s14sh3r||NJO, how much does the base itself weigh?|
|10-11-2013 08:42 AM|
A. Absolute strength and protection. It is the strongest of all the racks bar none. Its 350/1000lb. rating(moving/stationary) is highly underrated in my book. The base is made of 2" 1/8th inch thick DOM tubing(11 gauge). None of the other racks I researched compared to it. It also protects the rear tub corners from direct impact, scrapes etc.
B. Mounting points. No drilling into the body required. I personally didn't like the racks that use the rear tub as a base, just not as strong. It ties into and bolts to the frame directly in the rear. And uses the 4 A pillar bolts on the sides of the windshield up front. If you happen to have a 1" BL or so, they will provide you the proper spacers out back to compensate for this.
C. Does not hinder functionality in any form. Rear tailgate, front doors, installing or removing hardtop. Folding up or down the soft top including the sunrider feature. Don't need to tilt it or move/unbolt it to change the configuration of your jeep around necessarily. The base is out of the way.
D. Features, price etc. The base roof rack can be had for about $400 shipped(I got mine on sale for $350 shipped). It comes with 4 light tabs up front and 2 out back built in, allowed me to run the wiring inside the tubing neatly. You do not have to buy the top aluminum rack/wind deflector if its not needed. I originally started with the base rack and the adaptors for the Thule/Yakima base foot pads and bars I already owned for my kayaks,skis and snowboards etc, and then eventually got the top aluminum rack as needed for extra carrying capacity for camping. You can also mount all the other typical accessories on it like hi lift jack, jerry cans, pick n shovel, tools etc......since it uses standard 2" DOM tubing, there are a ton of companies that make adaptor kits that will just bolt right on to it, just like you find with the stock Wrangler roll bar. So you are not necessarily stuck to buying products for it from just one company which is a very nice touch.
Its just one of those products where you have to see it in person to see how well its built and how well it integrates with the Wrangler.
If you look at the pics above, you will see a 10 and a 16 foot kayak above my LJ. Those kayaks dry combined weight 150 pounds. They were both stuffed with another 100 pounds worth of gear EASY.........and I drove up about 2000 vertical feet over the course of about 4 miles to get to the top of a mountain with em strapped on. Including nearly a half mile of crawling through a real rocky dry river bed full of 1-3 foot tall rocks boulders that tossed the body all around with a lot of lateral forces places on the rack up top. It didn't loosen up, flex or squeak. Rock solid.
Some people may not need a rack as heavy duty. But if you do, then you should seriously consider this rack as a first option.
The only downsides I would say for it, is if you have a body lift larger 2" or larger, its not going to work without mods being done. And if you have an aftermarket bumper/end caps. Make sure it will fit, or be clearance to fit potentially. I run Metal Cloaks older modular rear bumper(which I see was discontinued)and end caps, and the bottom rear of the base rack was able to neatly fit into the end caps. The end caps actually give it an extra amount of protection on the bottom 90 degree bend. So the bottom corners of my tub are double protected by the end caps, and the rack base.
|10-11-2013 12:18 AM|
|Brad01||Can't decide between these myself|
|10-10-2013 11:33 PM|
|HotTotty||i'd post pics but it won't let me for some reason|
|10-10-2013 11:28 PM|
|HotTotty||I have the kargo master with a yakima basket. Great rack easy to take on and off. Plenty of room for my kayaks and camping gear. I would definitely recommend it.|
|10-10-2013 05:34 PM|
|Tdog02||I have the Garvin Wilderness rack, it came with my new to me TJ. I can tell you this from living with it... its loud at highway speed. Since most roof racks increase noise, thats not really a huge problem. I don't leave it on all the time but when its on it sucks a mile or two per gallon. That said, its stout, can be installed/removed by one person, no rattles, some pretty well thought out accessories can be purchased for it, I picked up the wind deflector and it cut down on the wind noise. It is so strong that you will be tempted to overload it. I have used it to stand on when trimming trees and it held up to that with no problem. I'm still debating what to use it for on my jeep but I am leaning toward using it as a platform for a roof top tent. FYI: you have to drill a couple of holes in the tub to install this rack.|
|10-10-2013 01:40 PM|
This one is on my Christmas list
|10-10-2013 11:48 AM|
|10-09-2013 03:45 PM|
|10-09-2013 03:19 PM|
|Rubicondon53||I want to add to my post with a photo now that I have some.. I maintain that most anything with hinges or lynch pins will eventually begin to rattle after a decade of highway/off-road use.. This thing is still solid as a rock... Simplicity = dependable. Just my humble opinion|
|10-09-2013 03:09 PM|
|commodore_dude||This is a good thread! I'd pretty much been set on getting a Gobi rack, but I didn't know some of these options existed (mainly I think I'd heard that the Garvin rack rattles, and that the Olympic rack rusts, and Gobi seems to have good customer service).|
|10-09-2013 02:54 PM|
|jasonduke5||I got mine off craigslist for 150 bucks.|
|10-09-2013 02:00 PM|
|c1skout||I've got a Cargo-Master that I bought used. Hell-for-stout and easy on or off.|
|10-09-2013 01:36 PM|
|jasonduke5||I am in the same boat as gold miner I love mine.|
|10-09-2013 01:04 PM|
|SnowboarderOx||What cross bars are you using on there?|
|09-27-2013 12:29 AM|
I exhausted this search last year for what I consider the best and strongest functional rack. My finding was for max durability, factory type integration, and overall design integration the Body Armor safari rack is top dog. It uses heavy gauge 2" DOM steel tubing throughout, and effectively acts as a perimeter armor cage for your tub(And its very effective too). Bolts direct to the frame/bumper tie ins out back(And Body Armor will send you a set of spacers if you have a body lift), and to the window/A pillars up front via 4 factory bolts. Load capacity is 350lbs while driving. OVER 1000 pounds stationary. Has 4 light tabs up front, and 2 out back. You can get rail adaptors for thule/Yakima bars, and they have an aluminum rack option. You can install or remove the hardtop with it ON. Soft top sunrider feature fully functional with it on, same with dropping the soft top too.
Base rack can be had for around $399, with another $399 for the top aluminum rack.
I was looking at a Gobi rack originally, compared to the Body Armor rack, its weak and flimsy, and it doesn't integrate near as well.
|09-27-2013 12:10 AM|
|InvictusDecretum||I have a garvin wilderness rack and love it. Bolts onto the A frame and to the rear of Jeep. Has an integrated license plate holder on the rear. I had it bedlined as well (unnecessary). If you ever want to remove your hardtop (or put the softtop down), you unscrew the bolts on the A frame and the whole thing rocks back. It also supports 300-400lbs, so I can throw a sheet of plywood up there and make myself a shelter to sleep in if I wanted. Only drawback I found was that to remove my doors, I had to rock the rack back. I suppose I could grind off part of the mount (only needs like 1/8th of an inch, probably because of the bedlining), but I have steel half doors and meh.|
|09-15-2013 01:02 PM|
|Rubicondon53||I bought my Warrior Safari roof rack back in 1998.. It is a well built, no nonsense rack. It does not rattle, or vibrate.. And unlike many racks, it looks as if it belongs on the jeep.. It is also the rack used on jeeps by the National Parks and National Forrest Services..|
|09-15-2013 12:53 PM|
I have the Kargo Master and have been loving it since 2001. Connects to the body using existing bolts. I carry a full rack of ladders on it occasionally (300lbs+) and it doesn't even flinch. Solid rack system. It's hinged on the back. Two 3/4" bolts up front. Unbolt those two front connections and it hinges back easily so that hard top removal and replacement isn't an issue. The newer Kargo Master system looks slightly different than mine.
Solid rack for sure. After 12yrs I still give it 5 stars.
|This thread has more than 30 replies. Click here to review the whole thread.|