|01-02-2010 06:21 PM|
Can't recall the specific part #'s either.
Do as TWOZEROFD suggested,
and read through the INTERIOR LIGHTING thread that we put together.
If I remember correctly, everything you need to know is in that thread in detail....both for the older model TJ's like mine, and the newer ones like his.
BTW TWOZEROFD... are your LEDs still holding up?
So far so good for mine...but I don't do a HELL of alot of night driving.
|01-02-2010 05:05 PM|
|abw0004||What was the size and type of bulb used for the PRND21?|
|01-01-2010 05:40 PM|
|Twozerofd||if you read the whole thread it says what bulbs fit where, i forget what size i used. i think the switch led's were smaller than the hvac led's|
|01-01-2010 03:58 PM|
|abw0004||Actually for the switches for the defroster and such, did they require the same bulbs that the hvac used?|
|01-01-2010 03:55 PM|
|abw0004||this helps a lot. thanks!|
|01-01-2010 03:39 PM|
|Twozerofd||Nevermind i found my write up. search for the thread "Interior Lighting" started by blacktoothgrin. go to page 3 of the thread, about 3/4 of the way down is my write up. hope it helps!|
|01-01-2010 03:31 PM|
|Twozerofd||give me your email. i did an entire write up on the HVAC dissasembly.|
|01-01-2010 03:31 PM|
|kdukes4||there should be two plugs that look somewhat similar to the ones that you pulled in your cluster, one on each side of the hvac unit. those are the bulbs. just have to turn it 1/4 of a turn and it should come loose to pull out. i tried putting my leds in there and they kept blowing on me... i just put the old ones back in.|
|01-01-2010 03:10 PM|
|abw0004||Do I need to disconnect it from the harness? And does it come out from the back like the gauges did or do I open it up?|
|01-01-2010 03:05 PM|
|ilovegeeksnj||1st take the middle trim piece that goes around radio and hvac. then remove the hvac screws pull it out a bit and there are 1 bulb on each side they look the same as cluster. its very easy|
|01-01-2010 12:25 AM|
HVAC LED light install question
I am replacing the hvac bulbs with blue LED's and I am confused on how to get the original bulbs out and these in. I already replaced the gauge lights and I know how to get the housing for the hvac controls off. Pictures and directions would be greatly appreciated! Thanks!