|01-13-2010 06:47 AM|
|Rammer500||Crawl under the Jeep and see how much of the bolt is sticking through. If there is enough to get a set of vise grips on it, remove it from the bottom.|
|01-13-2010 02:02 AM|
When you drill it - use a reverse drill (available at Autozone.) Often the drill snags and screws what's left of the bolt out.
A reverse drill turns counter clockwise to cut, and you'll need a reversible drill motor.
|01-13-2010 01:47 AM|
|01-13-2010 12:43 AM|
if you can't get an extractor to pull it (I've broken more than my share), then get your hands on a set of good drill bits. Start small, and drill out the center. Get progressively larger diameter bits, being careful to drill straight down through the center of the bolt. Once you've gutted it enough, it should pull right out.
Another method I've seen work well is if you've got enough of the bolt sticking out above the bolt hole, you can cut a straight line through the top of the bolt with a dremel and use a flathead screwdriver to get it out.
Also, never underestimate the power of a buttload of PB blaster.
|01-13-2010 12:20 AM|
|sjbable||no they are just bolts. i took my rear seat out to roll on truck bed liner and 3 of the bolts broke. i just drilled them out and replaced them with a nut and bolt combo. good luck|
|01-11-2010 04:08 PM|
|600RRJeep250F||k thanks guys. oh and those seat bracket bolts dont have nuts on the other side do they?|
|01-05-2010 05:26 PM|
|woods453||If you don't have a welder, drill a hole in it and screw a bolt extractor in there.|
|01-05-2010 03:32 PM|
|T-BONE N BIXBY||
Weld a nut to the broken stud, then start crankin!!
I see you're a Saluki.....about 90% of my family lives around Marion. Southern Ill sure is beautiful country.
|01-05-2010 01:36 PM|
Busted Bolt Question
OK so when i was rhino lining the inside of my jeep i took off the rear seat brackets and the bolts snapped. what is the best way to go about getting those out so i can replace them and put my rear seat in?