|10-14-2013 03:41 PM|
|cjyjjeep||it was my flex. i guess i was use to my xj with no sway bars|
|10-13-2013 12:15 PM|
|Warren544109||I don't know if this is the same issue but when I first got my jeep the 4x4 wasn't working. But when I lifted one side off of the ground and kept playing with the 4x4 lever the front wheel would spin but a lot slower ad I was able to stop it with my foot. When I opened the transfer case the shift fork was worn down to a point on one side and was not properly engaging the 4 wheel drive.|
|10-13-2013 12:12 PM|
To me, this sounds like you are reaching the limits of the Jeeps suspension, and it can no longer flex any more to provide appropriate traction.
Are your Track Bars still installed?
|10-13-2013 11:48 AM|
|cjyjjeep||no clanking like anythings broke and they both grab they just give out under pressure|
|10-13-2013 02:35 AM|
I was going to say the same thing, maybe a twisted shaft. Could be the Splines at the CAD are gone as well.
Never herd anything like this. Very strange...
|10-13-2013 12:51 AM|
|Fabrokoner||Broken axle shaft???|
|10-12-2013 10:17 PM|
|cjyjjeep||if one front wheel is setting without much weight.. yes it spins but if both front wheels are holding a load just my back tire spins out..... i can feel it start to pull up a small hill but as soon as it starts to grab and starts taking on some weight it gives out.... this is a small hill not bigger then half my 31 inch tire and has a steep ramp...|
|10-12-2013 08:19 AM|
|10-12-2013 01:33 AM|
Just to clarify, the front end is engaging, correct? When the back wheel spins out, is one of the front wheels spinning out as well?
Your wording is a little on the confusing side. No such thing as a "weak" 4x4. You either have power to both diffs or you don't. Changing from a CAD to the cable has no effect on performance. You're simply changing something that was automated to manual. The end result stays the same.
|10-11-2013 06:54 PM|
When you go wheeling do you air down at all??? I ran a D30 open and D35 open all last year in some very interesting areas on Rocks rock waterfalls, loose sand hills, loose shale and gravel hills with no issues and usually a very slow crawl lots of low range and never had an issue with wheel spin. I am very conservative with the skinny pedal since I had a D35 in the rear.
I was very happy with setup but this summer I swapped the rear for an 8.8 had a Grizlly put in and added a Lock Rite in the front. Now its a beast on the hills and I love it. With 8.8 I have no fear of breaking an axle so on to the more advanced rock crawling here in the Desert west.
|10-10-2013 04:15 PM|
Shows: DSA Anti-spin differential in the rear axle section.
|10-10-2013 03:39 PM|
|djwrangler||The issue you are describing sounds exactly like an open diff working it's magic. Or bald tires...|
|10-10-2013 03:34 PM|
|cjyjjeep||Weak means it grabs when aproaching a small hill but as soon as it does grab my back tire spins out... i can not approach slow and crawl up anything....open diff isnt the problem. i know the difference in a problem and just a normal stock jeep.|
|10-10-2013 11:38 AM|
|10-10-2013 11:29 AM|
|10-10-2013 11:26 AM|
|10-10-2013 09:34 AM|
|10-10-2013 09:03 AM|
|dancin1||I had the same problem after the cable installation. The fix for that was a auto locker. The open diff was the problem. the auto locker fixed it. I had no problem with the factory limited slip in the rear, now, the front end seems to be pulling me through any mud or otherwise sticky situation.|
|10-10-2013 08:49 AM|
|10-10-2013 08:19 AM|
|10-10-2013 12:47 AM|
|jokerchief462||During the cable install the instructions show and tell you to adjust it for enough throw to engage the collar over the two shafts. Maybe check it.|
|10-09-2013 09:49 PM|
|manasterskimike||mine was the same i put it up on jack stands and it would work so i pulled the vacuum off and put a cable on it worked on the stands i havent gotten a chance to try it off road but i hope it works i need it in afew weeks. if it dosent work what could be the problem if it works on the stands but not whn i need my front axle to spin?|
|10-09-2013 08:01 PM|
|harleydragon||what is it doing|
|10-09-2013 06:42 PM|
My 93 wranglers 4x4 works but is real weak? Doesn't have vaccum anymore its upgraded to cable.