|10-18-2013 03:33 AM|
|Shawnbn||We just bought it and the lights aren't wired in yet. That's my next job. And I like the orange jeep. It matches the color of the jeep. Lol|
|10-18-2013 02:53 AM|
No, you can't tell from that picture. A real "fog" will have a piece of metal wrapped over the bulb right behind your "ee" i jeep. Another way to tell is to turn them on and take another picture. A real fog will be completely lit up in the bottom half, and almost no brightness in the 4 grill squares above you "ee"
...or turn them on at night against a wall and check the beam for yourself. a fog will make a bright horizontal bar of light, some light scattering below that bar, not much light above that bar. a flood will put out a large soft area of light like a house lamp, and driver/euro will have a very obvious hot spot in the center. From the lens, it can only be one of these 4 types( it's not a spot like someone else said). The only reason you would want to know is of course, if it's a real fog, you definitely don't want it up there. so when are you going to black out that orange writing on the lights? That's bright enough without turning them on. LOL
|10-17-2013 08:14 PM|
|reno92||The two center lights look like spots and would be fine. I can't tell if the two outside lights are fog or driving. Driving won't be as bad a fogs up there, but spot or pencil is what you want. A spot or pencil will normally have a clear lens, no grooves in the glass. Fog and driving will have grooved lens.|
|10-17-2013 08:03 PM|
|Shawnbn||From the pics I uploaded can you tell what type they are?|
|10-17-2013 02:24 PM|
|10-17-2013 02:14 PM|
|Shawnbn||Thanks all for the info. I believe they are driving lights. And for the wiring yes I will be using a relay. And I planned on switching out the torx for hex|
|10-17-2013 01:16 PM|
What's more strange to me is that it came with 4 installed lights with no wiring installed.
My advice would also be to take the 2 fogs off the roof and get them down on the front bumper then buy another set of spots, drivers or even euro beams to put up there. Fog's don't belong up that high up with their wide and narrow beam, you basically need to point them nearly straight down at the ground to see them light up anything useful. ...that is if they're real fog reflectors with the shield over the bulb.
|10-17-2013 01:05 PM|
|W5KVV||Black is always ground on a 12 volt system.|
|10-17-2013 12:57 PM|
Black is always ground White/Red are always Hot !
|10-17-2013 11:31 AM|
Shawnbn, Welcome to the club. Lights will be just the beginning.
Use black as the ground, same at the battery terminals/leads. Are you wiring in a relay with that many lights?
|10-17-2013 11:11 AM|
|Hip To Be Square||
Good luck on the new jeep!
On a side note, for what it's worth, I too would wire the white as hot and the black as ground- just for uniformity's sake.
|10-17-2013 10:17 AM|
|10-17-2013 09:18 AM|
|Shawnbn||Also what size torxs is the seat belt holder? I have to replace the back seat seat belts so the baby's safe. Thanks for all the support.|
|10-17-2013 08:48 AM|
|Shawnbn||Okay and when I wire the lights in and run them through the tube, what would be the best area to run them into the cab. Through the window frame or through the body under the window frame.|
|10-17-2013 08:31 AM|
|Decoy_58||I would wire black hot white ground or if you have a multi meter you can check to see which one is ground|
|10-17-2013 08:11 AM|
Need help with my kc lights.
My girlfriend and I just bought a 91 wrangler and it came with 4 kc lights on a overhead light bar. Two are floods and two are spots. The wiring is black and white. Which one is hot? I think it's the white but just want to make sure before I wire them wrong. Thanks.