Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > P0457 not the gas cap.

Join Wrangler Forum Today


Thread: P0457 not the gas cap. Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-19-2013 01:27 PM
kylekae Took it to the dealership and the lines on top of the tank were cracked and leaking vapor
11-12-2013 04:23 PM
ChaddG check all the rubber connectors going from your evap to your purge, to your intake.
I'm betting it is a rubber fitting. I had the same codes. minor leak and large leak.
I would assume the gas cap usually doesn't go bad.
I got my hoses from the dealer, cost me 40.00 for the set. replaced em, cleared the codes, and never returned. there is a green cap next to the evap on mine and the rubber fittings were cracked in places that weren't obvious until I took the lines off and inspected them.
Good luck.
11-10-2013 07:03 PM
lt706 With a fuel pressure gage you hook it up to the fuel rail
11-07-2013 10:16 PM
kylekae No how would I do that? The car runs fine. No sputtering
11-07-2013 06:57 PM
lt706 Have you checked the fuel pressure yet?
11-06-2013 09:05 AM
kylekae Bump
11-03-2013 07:01 PM
kylekae Just got p0700 along with p0456 again. I think my tcm may be shot. Or any ideas?
11-01-2013 01:27 PM
kylekae The savvy skid does have an indentation for the fuel pump. So I think I may go get a smoke test
11-01-2013 12:05 PM
Habib My Jeep had a leak around the fuel pump/sending unit gasket on top of the tank. Fixed under warranty, even though it has Kilby tank skid.

If the Savvy skid doesn't have a recess for the reservoir, it could have compromised the gasket. Pretty sure my Kilby did.
11-01-2013 11:25 AM
gmiller0737 Best way to diagnose is to follow the Diagnostic "Tree" in the service manual, Followed by a thorough inspection of all hoses & such,A smoke test may be needed as well
11-01-2013 09:01 AM
kylekae Found mine and it was under the hood exactly as the diagram. It was upright. Also took the gas cap to the emission place and tested the cap. It is GOOD. I hate this gas tank. I have had it replaced twice, dealership paid for it the second time because they screwed up. Then I put a savvy gas tank skid on so I'm not afraid to drop it now. And don't want to pay the dealership 1k again. Should I take it and get a smoke test in the tank. Or take it to the dealership.
11-01-2013 06:04 AM
Greentj05 Actually, if yours is an 06' it should be tucked behind the R/R wheel behind the inner fender. Sometimes an internal fault with some of these parts can throw false "leak" codes too.
11-01-2013 05:21 AM
workshop4ever Drivers side of the engine bay.
10-31-2013 08:46 AM
kylekae
Quote:
Originally Posted by tuleyoil View Post
I would look at the solenoid. It should be labeled "TOP" and obviously....that side should be on top.
Where is this solenoid located
10-30-2013 10:32 PM
tuleyoil I would look at the solenoid. It should be labeled "TOP" and obviously....that side should be on top.
10-30-2013 09:39 PM
dcmtex Check the evap canister under the battery. Mine was ate up. Stop eating the beans and the gassy smell will go away Good luck!
10-30-2013 09:23 PM
kylekae
Quote:
Originally Posted by lt706 View Post
Can you see the fuel pump the plastic nut that holds it in can pop loose causing a vapor leak this happened to me and took me months to figure it out
I may drop the tank and check tomorrow
10-30-2013 09:21 PM
lt706 Can you see the fuel pump the plastic nut that holds it in can pop loose causing a vapor leak this happened to me and took me months to figure it out
10-28-2013 09:09 PM
kylekae No hard starting but the garage smells kinda gassy every now and then. But the car only has 50k and I had the tank replaced by the dealer for the same reason last year.
10-28-2013 08:47 PM
ztman Mine did the same thing, dealer replaced the EVAP solenoid. Smoke test and solenoid was about $300
10-28-2013 08:41 PM
lt706 Beside the code does it start hard or have a loss in power? Can you smell any gas fumes?
10-28-2013 10:10 AM
KaiserJeep The dealership DOES have a smoke generator they can use to find leaky hoses. They charged me $328, mostly labor, to drop the tank and find/replace two leaky rubber hoses. It was over and done in a half day and has not come back in three years.

I was expecting this to be a repair covered by the emissions warranty and it was not. The emissions warranty only covers the converters and other "major components", not including hoses. This repair happened about 2 months after my seven year bumper-to-bumper warranty expired.
10-28-2013 09:29 AM
kylekae So the damn night came back on and now it's p0456 and 457. Ideas? Should I just take it to the dealership?
10-25-2013 12:34 PM
kylekae I re tightened the fule filler neck and reconnected all the fuel line and it has seemed to go away
10-23-2013 07:59 PM
workshop4ever I had the same problem recently and found that my EVAP solenoid was installed upside down. After you double-check the cap, check every inch of the lines, I would look at the solenoid. It should be labeled "TOP" and obviously....that side should be on top.
10-23-2013 06:19 PM
lt706 Is it running rough or hard to start at all?
10-23-2013 03:37 PM
bigcat I'd check that moose cap (kidding). Check the evap cannister, and the lines especially...I had a few rot holes in mine that caused the code...Then you can go back to your original cap. I hated the replacement
10-23-2013 03:05 PM
Big Sarge If you are 100% positive that it's not the cap (i bet it is) then you have a large evap leak somewhere. Lots of good info on the web, 99% point to a bad cap.

P0457 Jeep EVAP System Loose Fuel Cap OBDII Engine Light Trouble Code | Engine-Codes.com
10-23-2013 03:02 PM
kylekae I just got one at napa I don't think it's moose. But say it's not the gas cap. What could it be.
10-23-2013 02:59 PM
Big Sarge did you replace with a Mopar cap or a cheap china made replacement from an auto parts store?
This thread has more than 30 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:02 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC