|03-17-2010 02:31 PM|
|armytucson||s3nt3nc3d and 03 RUBI have covered everything that I can think of. last option is to upgrade your fog lights and run new wiring.|
|03-16-2010 07:26 PM|
|03 RUBI||Step 1: unplug the fogs at their connector. Step 2: with the stalk switch on, do you have 12V? If yes, it's the lights themselves. If no, check the fuse. If the fuse is OK then it's between the switch and the fuse. Also, there's a relay that shuts off the fogs when the hi beams are on. Good luck!|
|03-16-2010 07:21 PM|
First thing I'd do...check your bulbs, not likely, but you'll be ticked if that's the culprit. If your bulbs are good, make sure their ground is still intact (not sure if they're grounded at the bulb or down a wire and grounded into the engine bay somehow. Regardless. Make sure it looks connected. Also check for voltage at the bulbs...if you're getting voltage at the bulbs, you either have a bad ground or your bulbs aren't getting a good connecting in the housing.
If you're not getting ~12v at the bulbs, follow the wiring back until you get ~12v. Whatever component your voltage stops at will be the culprit. If you get back to a mess of stuff... I can't help ya there...not without seeing it anyway, but if it's a simple problem, hopefully you won't get that far. You also could have a bad fog light switch and you'll need to replace it.
|03-16-2010 07:12 PM|
helps fixing fog lights
Hey everyone. I just joined the forum and im looking for it DIY on fixing or replacing the fog lights on my 97 wrangler. They have simply stopped working. I havent done much to figure out why they stopped. I drive a mazda3 and i used the forums to pretty much do everything. ANy help would be appreciated. thanks