|10-29-2013 03:19 PM|
|10-29-2013 03:04 PM|
4 Rectifier Diodes #IN4004
2 560 Ohm ˝ watt Resistors #271-1116
3 Colors 18 gauge wire
then solder them up like the picture below and ground the negative wire of the led and you should be good to go. Just be sure and insulate the bare wires then place the whole thing in a piece of tubing or something else semi rigid.
This will allow the led to be the marker light plus blink when your turn signal is on
|10-29-2013 02:42 PM|
front ones are ok as is. it's the ones on the sides i'll to replace.
Hoping to not have to do a big mod for them
|10-29-2013 02:31 PM|
|Owen_TJ||I dont have side markers on mine but i used the stock signal from a wrecked JK which fits the stock tj bulb...just relocated them into my grill.|
|10-29-2013 12:02 PM|
Point me in the right direction - side turn signal
Getting ready to cut my stock flares and I remember seeing some place on this TJ section someone found a turn signal housing that the stock bulb fits into. Maybe from tractor supply.
or if someone has found a real easy way to wire in a new LED and still get them to flash that would be cool to.
thanks for the help