Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Tech Forums > Communications and Electronics > Subwoofer stopped working.

Join Wrangler Forum Today


Thread: Subwoofer stopped working. Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-06-2010 03:01 PM
Jaydogg25 here's what i do when i trouble shoot a issue like this.

1) i start @ the amp. is there a power light on amp? you said it starts red then goes green...red normaly means protect but since it's not stayin on i will assume thats ok. now does power light stay on?

2) at the amp connections, w/ a test light. test Constant, Remote & Ground.
-if any of these 3 wires are not working then start checking that wire till you find/fix issue.
-if all 3 are fine then look @ fuses, if there are any, on that amp. Test them w/ the test light both sides should have power.. never just look @ them, they could look good and still be bad

this may seem like a waste of time but trust me i have seen some amps turn on it's light for just a ground and one of the other 2 and will drive you nutz.

if everything @ amp seems fine. then i would move on to a couple other things.

3) if you can un-hook speaker wires from amp and use a multi-meter and test Ohm load of the speaker. most common ohm load for car audio is 4. you should be close to that. if you get nothing or a very low number then could be a blown sub or speaker wire come unhooked from speaker.

4) check/test RCA's from radio to amp. if you have a friend with a system that works you can do this easy by jumping a rca from his radio to your amp. if you amp turns on then either rca on your radio is bad or you may have a "sub control" and sub is either muted or shut off.



hope that helps some
04-06-2010 02:07 PM
pking911 do you have access to the wires where the sub connects? it still could be something wrong with the sub instead of the amp.

just a thought.
04-06-2010 09:23 AM
Jma20a ^its a powered sub, its just one unit all together

it could be a bad ground, i would check all the wiring to make sure everything is connected properly.
04-06-2010 08:48 AM
pking911 aftermarket equipment, check all connections.

Start with the head unit. Check to verify that your remote turn on and rca-preamp outputs are connected properly and securly.

Check your amp. is your amp working? can you connect a different speaker to it to test it?
If the amp is not working, check your remote turn on lead for shorts or cuts.
If the amp is working with another speaker, then its a bad sub possibly. Check the connections on the sub and inside the sub box.
04-05-2010 11:46 PM
aenima540 No sorry was so frustrated in the first post, it's a boss bass1200, it's mounted under the rear seat in my 94 YJ
04-05-2010 07:43 PM
Jma20a is it the factory sub in the console? need more info here to help.
04-05-2010 07:02 PM
aenima540
Subwoofer stopped working.

Okay so, today i get to school and we have speed bumps going down the parking lot, i go over the first one, and a slow speed under 5 MPH like always, and after i go over it my sub just stops bumping, nothing coming out of it.... So i'm like maybe it over heated i'll let it chill til after school, nope, so i'm home from practice now, i tried reconnecting everything, still nothing. the light when i turn it on is red for a little bit, then turns green shortly after... Very confused as to what I am to do here, if you read alot here I just installed this 2 weeks ago :/

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:06 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC