Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Soft top rear window?

Join Wrangler Forum Today


Thread: Soft top rear window? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-14-2010 10:32 AM
woodsballnc I just use the brackets on either side of the tailgate to slide the belt in. The top i had was old as dirt and looked like it is missing that bar.
04-14-2010 10:24 AM
3025826
Reply

I just lower the bar that tightens the soft top and unbutton it from the back. Then i just undo it from the front. I don't unzip or re zip anything until i have it off the car, it is much easier this way and takes about a minute to take off and 5 to put back on solo.
04-14-2010 10:09 AM
Neil F. Yes you need the bar and brackets to secure the rear window. If you orderded the RAT, that means you have a softtop already, correct? If so, how is your rear window secured now?
04-14-2010 09:08 AM
woodsballnc A little off topic but I dont have a bar neither and just ordered a RAT will i need to order one for my top to fit?
04-14-2010 08:54 AM
InfernoGirl
Quote:
Originally Posted by Wolf74 View Post
Ahhh, I think the problem is that I'm missing those side clips where the center bar is supposed to just clip into. They're not attatched to the window nor the actual tailgate (or the sides for that matter). I'm guessing the previous owner might have lost that part of the hardware and thats why I don't have it. I'll have to look around and see if they were just misplaced or fell off or something but I'm getting the feeling I don't have them at all.
The brackets are screwed to the tub on each side of the tail gate.
You can see them here: (please excuse my drawing skills... apparently this is harder than it looks...
04-13-2010 10:26 PM
Wolf74 Ahhh, I think the problem is that I'm missing those side clips where the center bar is supposed to just clip into. They're not attatched to the window nor the actual tailgate (or the sides for that matter). I'm guessing the previous owner might have lost that part of the hardware and thats why I don't have it. I'll have to look around and see if they were just misplaced or fell off or something but I'm getting the feeling I don't have them at all.
04-13-2010 10:19 PM
jamesdeanblvd I just got another soft top and new windows a few weeks ago, and I must admit, I struggled with the rear window. I've got a friend who deals in Wranglers (over 50 in stock) and went to his shop and he showed me. He first got WD40 and sprayed on the first 6 inches of the zipper on the drivers rear side. You should have to zipper clasps that need to be on the left side at first. Once you get the zipper installed in both clasps, zip the upper zipper clasp all away around the window so you have one on the bottom of the left and right side. Then all you have to do is unzip both sides straight up, and then roll the window up and use the straps included to snap it. Once he did it, I felt pretty stupid, but, who cares, it's done now. Good luck.
04-13-2010 09:52 PM
TroyD
Quote:
Originally Posted by TJNewbie View Post
which one did you get from bestop? I'm thinking about getting the replace-a-top, with tinted windows.
thats what i got.....black denim....it proved much easier with two people than just lil ol me while installing it...and the directions were dead nuts accurate and well explained,,,except for one step. but it was a breeze. and them tinted windows are nice too.
04-13-2010 07:35 PM
TJNewbie which one did you get from bestop? I'm thinking about getting the replace-a-top, with tinted windows.
04-13-2010 06:21 PM
TroyD just installed my new bestop last week. it was a breeze installing it. nothin hard about it. im well pleased with the outcome

those brackets are on each side of the tailgate. bar slipes right into them. removes easily too.
04-13-2010 06:17 PM
Geoff@Bestop It's not a good photo, but this shows the tailgate bar plus the two brackets that would be attached to the Jeep
04-13-2010 06:15 PM
InfernoGirl The bar attached to the window is what you need. It rolls under/clips into the retainer clips on the sides in the back. Google soft top installation videos on youtube, and you should find one to show you how to do it
04-13-2010 06:15 PM
Geoff@Bestop Your tailgate bar may be attached to the window, which is good.
Now you need to attach the tailgate bar to your Jeep.

Do you have little brackets on either side of the tailgate where this bar would just snap into?

04-13-2010 05:51 PM
Wolf74 I think that might be missing from my tailgate. The only bar there is the one attatched to the actual window itself with the weather stripping. But I don't have anything attatched to the tailgate itself, or the sides.
04-13-2010 04:49 PM
Geoff@Bestop Do you have the tailgate bar? There's a thin metal bar with some gaskets on it that spans across the top of the tailgate. The rear window slides into that - there's a u-shaped groove in the tailgate bar that it slides right into.
04-13-2010 04:44 PM
Wolf74
Soft top rear window?

This is a newbie question but bear with me. I recently changed my TJ's hard top to the stock soft top however I'm having a hell of a time trying to figure out how to put in the rear window. I zipped it all up but the trouble I'm having is with the bottom rail part. I've racked my brain trying to figure out how it goes but haven't been able to figure it out! I could use any help you guys can give me, and a pic of how its supposed to look would help too. Thanks!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:43 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC