|04-18-2010 06:59 AM|
|cru9||I am going to climb under there today and look again. I didnt see any adjustment but like I said I was on the trail and was mad as hell. I emailed the guy who installed but like my luck goes no response.|
|04-17-2010 10:25 PM|
|jdhallissey||Instead of the lowering kit, jump up underneath and adjust the rod going into the t-case. I didn't have to run a lowering kit on mine with a tcase drop. If you do no biggie. If you need one let me know I can get mine in the mail to ya.|
|04-17-2010 09:45 PM|
Yep, you should have an adapter plate that came with it somewhere. Should look like like a metal plate with several holes poked in it. It will lift the linkage up an inch or two to get it back to normal height.
|04-17-2010 09:39 PM|
|cru9||On the rough country lift it comes with 2 bars that go on each side and lower the transfer skid pan about an inch and half or so.|
|04-17-2010 09:36 PM|
It helps keep the driveline angle from getting too steep if you don't have a SYE and CV driveshaft installed (otherwise you can get bad vibrations in the driveline). It looks kinda like this (although your TJ one would have more pucks)
|04-17-2010 09:30 PM|
|cru9||What is the tc ase lowering kit?|
|04-17-2010 09:17 PM|
Well, are you using a t-case lowering kit or do you have an SYE etc. installed? If you are using the tcase lowering kit, you will need an adapter for the linkage. If you have an SYE installed and are not using the tcase lowering kit, you should not need the adapter, and probably just need to adjust your linkage (unless you have a body lift also, which would need the adapter then as well).
At least that's what I think, others will know better I'm sure
|04-17-2010 09:10 PM|
|Ken Steele||Should have come with a bracket/s to relocate the linkage set up by an inch or two.|
|04-17-2010 08:44 PM|
Shifting to 4 low problem
I have a new 4" roough country lift and went to the woods today and can not shift to 4 low. It is binding up. It shifts into 4 high with no problem. Should there be a extension for the linkage for the 4" lift?