|04-22-2010 02:28 AM|
|jiggs26.2||Replaced clutch, master cylinder and slave cylinder and problem is fixed.|
|03-30-2010 09:12 AM|
|jiggs26.2||Took it into the shop today. They said I need to replace the clutch and the master cylinder.|
|03-29-2010 11:47 PM|
|jiggs26.2||Already done that. It is full. Thanks though.|
|03-29-2010 10:31 AM|
|Atthehop||The clutch is hydraulic, check the fluid in the cylinder.|
|03-29-2010 06:33 AM|
2003 Wrangler Clutch Problem
I have a 2003 Wrangler Rubicon with the I-6 engin. This weekend while driving I was trying to shift into 3rd gear and it would not go so I pulled over and played with it and finally got it to go into gear and all seemed fine. Then I got about 300 more yards down the road and when trying to change gears it would grind real bad and the clutch is very hard to depress. At this point I came to a complete stop could not get the jeep in gear and the cluch is had to depress. Was wondering if anyone had any ideas of what may cause this and what I need to do to fix it. I do have basic mechinical knowledge but not much on clutches or clutch problems.
Thanks in advance.