Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Cranks but no spark. Help!

Join Wrangler Forum Today


Thread: Cranks but no spark. Help! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-26-2010 08:19 PM
carlyj i just got rid of my ign module and put in a HEI. works all the time. crtperformance.com.
04-25-2010 02:23 PM
GMiller OK I swapped back to the original ignition module and it runs.
04-23-2010 11:11 AM
GMiller
Cranks but no spark. Help!

I need to give the history on this so be patient.
89 YJ, 6 cyl, new Howell FI kit. The Jeep lives at 8000 ft so the FI kit was a no brainer, it had a problem stalling and not re-firing on occasion. Sometimes an hour later it would start or a week later, sometimes right away. No pattern at all.
OK so the FI kit was to fix all the Carter BBD issues and while it was down I figured I could fix the intermittent start issue too. I checked around and the most likely thing was a crank position sensor except no sensor on this model.
I changed the ignition module when I did the FI and all was well. Ran great started no problem. I needed to check the timing, pulled it into the garage and hooked up the timing light - no start, turns over fine. Checked the voltage into the coil w/key on, 7v, cranking 12.7v just like it should be but nothing from the coil. Changed the coil, still nothing. Changed the pickup sensor, cap and rotor, still nothing. Well actually a very weak spark from the coil but nothing from the plug wires. Found a blog that said the resistor wire to the coil could be bad but I tried jumping straight from the battery to the coil and still nothing, that and the correct voltage to the coil made that seem unlikely. I had 4 buddies who are pretty sharp come by and they all said it should start.
I can't keep throwing parts at it cause there's nothing left to change! HELP!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:40 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC