|05-11-2010 09:36 AM|
|dbbd1||Good info. I was just about to pull the trigger on RE's.|
|05-11-2010 01:10 AM|
|SuperMario||Alrighty, Thanks Schmo!|
|05-10-2010 08:04 PM|
|Schmo||The instructions from Currie say 90 pounds for the lowers.|
|05-10-2010 07:37 PM|
|SuperMario||Anyone know what they're generally suppose to be torqued at. I've read 85 at the axel, 120lb at the frame.|
|05-10-2010 06:31 PM|
|05-10-2010 05:29 PM|
I didn't do currie arms. I had a set made and used Currie JJs.
These are HereticFab 4340 2" .250 wall with bungs for Curries 1.25" JJs. Right hand Left hand threads for easy adjustment on the jeep.
|05-10-2010 05:26 PM|
Yeah just the lowers. Should be relatively simple then.
|05-10-2010 05:13 PM|
|jdhallissey||Your doing the lowers? Honestly you don't have to jack the jeep up or even take the tires off if you don't want too. It will give you more room tho- jack the axle up pull tires and you can take off both lower arms at once and put the new ones in. The axle will not rock forward or back if your upper control arms are tight like they should be.|
|05-10-2010 05:11 PM|
No more RE time for JJ's
Purchasing 4 Currie JJ CA's instead of replacing the rubber bushings on my RE's all the time. Anybody else done this? I'm not too sure as to how to replace them though, I've heard put the frame on jack stands, take tires off, then put a floor jack under the axel for support then replace them. Seems easy enough. Then I read that you actually just need to take one CA off at a time, replace it then continue. Any inputs? Thanks.