|05-18-2010 08:57 PM|
|DCNKY||Followed your advice and leak is gone !! Thanks to all for your help !|
|05-16-2010 08:30 PM|
|jdhallissey||also you can run a small bead of RTV on the seal too. Funny thing is you said yours was leaking after you got done. Mine leaked for like 3 days then stopped lol. Has not leaked sense. Yes I do have gear fluid in the diff too lolol|
|05-16-2010 08:25 PM|
|harleyharv||A thin coat of BLUE loc tite helps too.|
|05-16-2010 08:00 PM|
|DCNKY||OK....... Will do.......thanks|
|05-15-2010 08:24 PM|
|baja||When you take off yoke,sand the surface were the seal rides.|
|05-15-2010 07:11 PM|
|DCNKY||Well.............installed new seal Thursday....................leaking again !|
|05-06-2010 10:10 PM|
|DCNKY||Thanks.............I can do that !|
|05-06-2010 09:50 PM|
yes will take ya about an hour. Then when you do it a few times it will be down to about 10 mins.
Pull the 4 bolts on the driveshaft (yoke side)
bungie cord the driveshaft up out of the way.
Get a big breaker bar and bust the pinion nut loose and take it off.
When you pull the pinion yoke there might be shims behind it do not lose them. You must put everything back the way it came off FYI. Under all that there is the seal, pull it off with a screw driver. Then put the new one in by hand then I use a 36 mm deep socket to gently tap the seal down in place. Then put it all back together. Pinion nut should be tightened to about 165ish foot pounds.
Then your done
|05-06-2010 09:40 PM|
Front housing seal
I noticed a fluid leak at the front housing seal where the front drive shaft yoke connects to what I call a hog head. Is this a easy job to replace?