Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Rear axle alignment

Join Wrangler Forum Today


Thread: Rear axle alignment Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-24-2010 05:49 PM
Garyk If you're sure the center pin is seated and you're measuring to the same spot on each side of the axle, something is bent. Just for the hell of it, try taking off the wheels and measure to the center of the axle/hub from the center of the front frame bracket .
05-24-2010 02:33 PM
wansfel Measured from the center of the forward spring eye to the face of the axle tube.
05-24-2010 01:21 PM
Garyk I would get them as aligned as soon as possible. If one rear wheel leads the other it could pull to one side or the other depending on which wheel leads. In our modified race car, we purposely set one wheel leading to make the car turn left easier, depending on the track banking, but this is with locked rear axles. Your Jeep will dog-track as well.
Where did you measure from?
05-24-2010 08:46 AM
wansfel
Rear axle alignment

After installing a new lift kit (2 1/2") and centering the steering. Did some measurements and found the rear axle to be off by 3/4" measuring form the forward spring eye center to the face of the axle tube (right side being 3/4" less than left). How close should this be? There was minimal center pin protrusion above the 2.5 deg aluminum axle shims.

Any comments?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:46 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC