Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > soft top problem

Join Wrangler Forum Today


Thread: soft top problem Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-04-2006 02:06 PM
pennybuy
soft top probem fixed

Thanks to all, problem with soft top fixed. I got looking..it is a bestop...the front bar that goes across top of windshield has two lockdown brackets on it. It looks like a hinge but it isn't. There is a bolt in each side...i unbolted each side an all it has is a big lip that goes in a slot in the top of the windshield...I removed those and the bar then layed down flat on top of the windshield...I put the plates back on the bar..with the lip inside the windshield frame and put the two bolts back in...slipped the black plastic lip from the top back in the groove and then slid the bars behind the front seat back up to tighten the roof and draw the top tight....it is perfect now.

I guess whoever put the top on didn't know how it was supposed to work...just like me..lol.

Thanks everyone....now to work some more on the turn/hazard light problem...think I'll take someone's advice and tear out the alarm system that doesn't work and see what happens..

Thanks ...
Bill ..in Jacksonville Fla.
01-03-2006 01:58 PM
1BLKJP Sounds like your top fits more like a bikini with the channel or like the old style CJ/YJ tops fit.
01-02-2006 06:37 PM
Jerry Bransford It's obvious now that you have an aftermarket top, too bad because the factory soft top is such a great design.
01-02-2006 06:08 PM
pennybuy
Ref: soft top problem

Thanks for the info...I will get some pictures tomorrow and post them...there are no levers on the windshield frame or anywhere...mine sounds like the one described with the hard plastic lip on the front of the soft top...it fits into a slot along the bar above the windshield... but it seems that the bar should then roll down onto the windshield frame but it will not go all the way down... I will try and post some pictures tomorrow....

Thanks Bill
01-02-2006 05:49 PM
khenderson i'm not really sure what you are describing. some pictures would be great...it almost sounds like you don't have the factory soft top, but something like the halp tops use with a header bar and the front edge of the top slides into it.
01-02-2006 03:35 PM
Jerry Bransford The front of the soft top is held to the windshield with two clamps. Two levers draw the clamps up to draw the front down to the top of the windshield frame. Find those two clamps and lift them up so they clamp the top down properly.

If that isn't what's wrong, take a few photos and post 'em or send them to me and I'll help you figure out what's wrong.
01-02-2006 03:12 PM
pennybuy
soft top problem

I'm a proud new owner of a 97 TJ... however, I have a problem with the soft top. On the way home with my new purchase...the top came loose in the front above the windshield and started to blow back toward the rear of the vehicle.
I stopped and tucked it above the roll bar till I got home. I put it back in place in the slot above the windshield....it is on like a thick round bar. It appears that once in place you should be able to twist this bar down flush with the top of the windshield. Mine doesn't go down that far....

I'm wondering is this what it is supposed to do...it has like two hinges that go inside the round bar...are these springs..could they be sprung not allowing the bar to go all the way down flush on top the windshield frame...The front edge of the soft top when in place sticks up about 1 1/2 to 2'' above the windshield frame...

Thanks Bill

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 03:43 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC