|06-10-2010 07:08 PM|
|jr.||x2 on the ground it is usually the problem.|
|06-10-2010 06:28 PM|
|Got_Mud?||Check the ground wire only - ground it with a clip lead or even jumper cables - then check it...sounds like the ground is weak/failed and is using the other hots to complete the circuit.... Just a thought...|
|06-10-2010 03:45 PM|
you need to recheck your wiring. unless you damaged something else.
can you disconnect the wires and wire them one at a time to see if something changes? tried rewiring it?
|06-10-2010 03:27 PM|
|drivebytruckerz||Hmm.. good luck. I'm sure somebody more knowledgeable will have some help. Consider this a bump.|
|06-10-2010 03:18 PM|
Problem with turn signals and lights
Hello, this is my first post in this forum I looked around to make sure this wasn't posted before and cant seem to find anything about it so here is my problem any thoughts or ideas would be great
About a week ago I accidentally ran over the cord that attaches to a trailer for my jeep it was connected to all the wires for the turn signals in the back of my 88 YJ. I reconnected all the colors back together but for some reason now my right turn signal will barely light up and flickers very quickly. But when I use my hazards both turn signals work fine. If I am driving at night time with my headlight on nothing will work including my brake lights which seem to work fine and also when I am braking my dashboard will light up....
Its all very strange and I have been looking through the wires for a few days trying to see if there are any splices or anything but with no luck
Thanks if you can help that would be awesome