Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Hair pulling time

Join Wrangler Forum Today


Thread: Hair pulling time Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-06-2006 01:25 PM
pennybuy
replaced part

Well I've put two flashers in it just to make sure...they came from NAPA ...and I did have the man check to make sure it was the flasher that was called for...think it was an EP-27...

I believe an have been told it is a grounding problem..but I just can't seem to find out what the problem is...

The flasher connector has three wires...an input..an output..an a ground
I have voltage at the input and output..and when I check the ground wire it shows it is grounded...but...if I pull the cover off the relay and use my test light to ground the flasher on the inside circuit board ...then the flashers work...but the flasher clicks constantly....

I'm thinking now maybe the problem is in the turn signal switch itself...not sure...maybe the flasher has to only have a ground when the turn signal switch is on..left or right...

Guess i need to find someone who is better at reading a schematic than what i am...lol. I can do the testing if I know what to test and what I should be seeing or reading on either a test light or multimeter.

thanks for the help

Bill
01-06-2006 12:56 PM
JeepCrawler98 Maybe a dumb question - but have you replaced the flasher with a dealer replacement yet? (the part stores ones can be a bit crappy sometimes)
01-06-2006 12:31 PM
pennybuy
Hair pulling time

Well I've stuck my head and test light an multimeter into every nook and cranny I can think of and still can't get the turn signals/hazard lights to function on my 97 TJ...only thing I have accomplished is finding a new problem..my ignition switch doesn't seem to have a working ACC function.
Going clockwise it goes from lock..to nothing ..to run..to start. Maybe not having a ACC function also effects my turn signals but I don't know why it would...I'm not to impressed with the electrical schematic in my Haynes repair manual. Nowhere does it show where grounds are located...it shows the code G300 which i believe is supposed to be a reference....but no where does it show where to find the G300 ground location.

Well maybe its time to just leave the door off and use hand signals for turning...I think I remember them from back in the old days when turn signals where optional equipment....

Dang I must be old..

Bill in Jacksonville Fla.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:43 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC