Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > flywheel alignment question

Join Wrangler Forum Today


Thread: flywheel alignment question Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-26-2010 04:28 PM
thriftybrown
thanks

I checked more closely - all of the bolts spacings are 1.1 inch but one which is 1.25 inches.
06-26-2010 02:19 AM
Snuffy115 Mine appear evenly spaced but they're not. There is only one way all 6 bolts will go in. If it's not aligned right only two or three will go in.
06-25-2010 11:20 PM
thriftybrown I wish this 2.5 had unequal spacing or an alignment pin; mine has six bolts that appear equally spaced; I will look closer and measure the spacing with a vernier caliper; maybe one is shifted a bit.
06-25-2010 07:58 AM
Snuffy115 I have a 4.0 and the bolt pattern on the flywheel is NOT symmetrical, meaning the flywheel can only be bolted on one way.
06-24-2010 11:39 PM
thriftybrown
flywheel alignment question

Does anyone know how to confirm the flywheel is correctly aligned on a 2.5L 4 cyl [91 wrangler with 94 engine]. We are replacing the clutch slave cylinder and rear main seal. The flywheel completely covers the crank so I could not mark the alignment to the crank so I marked the flywheel by the starter. Unfortunately my helpers did not wait for me to get back to pull the last bolts and remove the flywheel, and the engine crank seems to have moved a little while they were taking out the last bolts. We think we have it correct but would like to confirm this before putting everything back together. Perhaps someone has a picture showing the flywheel with the position of the two sets of four notches for the crank sensor when the crank is at TDC. The Haynes book does not have pictures of the flywheel I have; the one they show has a large hole for the crank in the center; my flywheel has a small hole (about an inch) containing the pilot bearing.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:25 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC