Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Crank shaft position sensor

Join Wrangler Forum Today


Thread: Crank shaft position sensor Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-25-2010 11:31 PM
rrich That code is often set by a small exhaust leak. Extra air is drawn in on the O2 sensor. Yes, air can get in - the exhaust pulses and creates a vacuum between pulses, drawing the fresh air in.

Night or dark garage - have a helper spray WD-40 or a light oil in the throttle body while you get underneath with a bright pencil beam flashlight. You'll see a wisp of smoke coming out the leak.

Another reason the code sets - the O2 heater wire is disconnected or broken.
06-25-2010 02:57 PM
Jerry Bransford P0174 = "Fuel Trim System Lean Bank 2" which is not a problem I am familiar with. Here is the entire list of codes... Chrysler, Dodge, and Jeep Computer Error Codes
06-25-2010 02:35 PM
Mclaughlin_1234 Alright thank you but also my jeep pulled a code last night p0174 does anyone know what that is?
06-25-2010 02:19 PM
Jerry Bransford The CPS is located where the transmission bolts to the engine, up high on the driver's side.
06-25-2010 02:08 PM
Mclaughlin_1234
Crank shaft position sensor

Hey can any if you guys tell me details d were the crank shaft potision señor is located on my 2004 i6 please my jeep is misfiring and I've already placed the plugs and the coil pack, please help!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:55 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC