Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Question re: new wheels and tires

Join Wrangler Forum Today


Thread: Question re: new wheels and tires Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-27-2010 08:13 PM
thaduke2003 Yeah- 4.56's would be massive overkill- that'd leave you over 3K RPM's at 70 MPH on the highway- not cool. As I said, I'd recommend re-gearing only if you wheel frequently, or really feel the need to, and even then, 3.73's or 4.10's max- Mark W.
06-27-2010 07:10 PM
GroundHawg
Quote:
Originally Posted by fan45acp View Post
Listen, At LEAST 4.56 or 4.88's and do your lockers now. Two sets of gears,install kit,and labor @ $1500.
for 33's?

dude i'm on 35's, 4.10's, AND an automatic...a superchip covered it just fine. i'm not buying any gears.

when my jeep was stock the 4.10's with 32's were perfect. unless you live on a damn mountain, 33's with a chip and 3.73 will be fine.
06-27-2010 05:01 PM
thaduke2003 ^ Woah- a bit of overkill. And you don't lose power due to having to spin bigger tires- yes, this is SOMEWHAT true, but the REAL reason is:
Tires are gears!
Yep. In the power equation, the diameter of your tires helps determine what is known as the final drive ratio. Bigger tires lower than, reducing torque multiplication to the ground, causing the vehicle to feel, and be, slower to accelerate, same as if you re-geared from 3.73 to 3.21, for instance. The bigger the tire size increase, the lower the final drive gets. This is why you re-gear a vehicle for bigger tires.
As for re-gearing, if you have OEM 3.21 gears, try adding a Superchips programmer to re-gain some of your power, and also to adjust the speedo/odometer back to being accurate. I would recommend re-gearing as a last resort, as the 3.21's can handle 33's (it'll never be a rocket off the line, however, and you may lose ~1 MPG). Re-gearing will void your warranty with MOST dealerships for your entire axle at each end, and costs a LOT to do- it's up to you to determine if it's worth the $1K+ it'll run you, parts and labor.
If you REALLY want to re-gear, you can find a set of OEM 4.10 gears for not a ton of coin- NOT Rubicon gears, but '07/8 D30/D44 gears (I'm assuming you're not in a Rubi, by the way). They're uncommonish, but out there. Check Craigslist, and the forums.
Class dismissed Mark W.
06-27-2010 02:57 PM
fan45acp Listen, At LEAST 4.56 or 4.88's and do your lockers now. Two sets of gears,install kit,and labor @ $1500.
06-27-2010 01:17 PM
GroundHawg Everyone is correct. This is normal behavior.

You can either buy new gears, or try a programmer. Programmers are great if you're "just outside the reccomended gear ratio" and it's a bonus if you have an automatic transmission.

Since your complaining of power with 33's I'm sure you've got 3.21 gears. 3.73 is good for 33's and a manual, 4.10 is the best.

Programmers are $300. Gears are at least $1000. Try the programmer first. If you don't like it, get gears. The programmer isn't a waste either. It eliminated that throttle lag, and corrected the speedo. With 4.10's, a programmer, and 33's...you'll be in great shape
06-27-2010 12:00 PM
WranglerX2009 http://www.dirtroad.com/gc.htm/

TAKE A LOOK AT THE LINK
06-27-2010 11:35 AM
cremaley 4Jeepn: Can you explain the changing gears a little more. How is this done?
06-27-2010 11:22 AM
4Jeepn Normal to lose power with bigger tires, engine has to work harder to spin them. To correct, change your gears to a lower(higher number) set.
06-27-2010 11:15 AM
cremaley
Question re: new wheels and tires

Just had Khumo 33x12.5R17 AT tires on Rev 50 Caliber Black Machined Face Wheels insalled on my 2010 Jeep Wrangler Sport. Fully expected the MPG to go down but it also feels like I have lost power as well especially in 5th and 6th gears. Am I imagining this or is this normal when you go to bigger tires?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:32 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC