|07-08-2010 07:39 AM|
When you install the tops and passenger side first-then drivers side-the windshield latchs first, then START THE THUMBSCREWS, just to engage the threads
Starting at the windshield-set the pass. side twist levers-then the drivers side twist levers
Finally tighten the thumbscrews-just to finger tight, no more
Now if you don't like that sequence--great, do it your way, mine hasn't leaked in a year and a half
|07-07-2010 10:31 PM|
As long as your puttng the panels back on correctly and pushing the levers in those 2 screws should not be that hard to turn
I initially had this problem and relized I had skipped a step causing them to be difficult to put back on
|07-07-2010 08:52 PM|
Well, you probably haven't rolled your JK yet !!
|07-07-2010 08:44 PM|
|WranglerLou||just leave them out.. mine have been out for months with no problems.|
|07-07-2010 07:59 PM|
The seals between the "T" tops and the windshield/freedom top are secured enough by the windshield latchs and the twist levers--
The two thumbscrews-thru the soundbar, which connects the left/right sides, provide the only integral security for the tops center, across the width of the jeep--
This center security will keep the top from "FLEXING" due to air pressure and body torsions, causing degrading of the seals and sidewindow perimeters, with ultimate rollover safety !!
They should never be torqued any more than 'FINGER" tight !!
Oh, I made this up, but it sounds pretty good
|07-07-2010 07:32 PM|
|KBR97||Mine come off just fine.|
|07-07-2010 07:10 PM|
|07-07-2010 06:49 PM|
Hope that helps!
|07-07-2010 06:08 PM|
|jk'n||Ditto on mine. If I sock them down, they are very difficult to get started back out. I learned not to snug them down that tight. Compressing the seal a little is all that is necessary.|
|07-07-2010 06:03 PM|
|larry53||Unless you are putting them back in super tight, they should unscrew with ease. Mine is a 07, but I would guess that they are the same. Mine spin off pretty easy once the initial few turns are made from snugging them down.|
|07-07-2010 05:37 PM|
Jk unlimited Hardtop question
I have a 2010 Jeep Wrangler 4 door unlimited hardtop. I have a very very hard time getting the 2 screw bolts out to take off the tops that are over the front seats. I took it to the jeep dealer and they said there is nothing wrong with it. My girlfriend has brought it to the dealer several times and the mechanics had to come out with vise grips and a shop towel to turn them out. Is anybody else having any problems with these bolt/screws?