Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > 91 wrangler 4.0L hard start

Join Wrangler Forum Today


Thread: 91 wrangler 4.0L hard start Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-11-2010 12:46 PM
wrangler91blueballs Jeep is fixed, the on thing i didn't want to replace, THE BATTERY. Even though it had 12v everywhere the amps were low. Under a load test at AUTOZONE, it went 8, 6, to BAD BATTERY hahahah. Thanks people KISS Keep It Simple Stupid
07-08-2010 10:14 PM
wrangler91blueballs i have 12v every where when car is off, when i do get it to start i have 12-14v. alt is old but still putting out good voltage. do u think that would pull a draw when first trying to start?
07-08-2010 06:38 PM
flatline measure battery votage while off. should be over 12 volts. alt. should be a constant voltage greater than 13. and starting is a major draw. how old is the battery? do you still have the original alt?
07-08-2010 06:27 PM
wrangler91blueballs oh when it is running i have 12-14v. it will act as if the battery is dead and ill get click click, cycle key go to start, it will crank slow and then finally start after 20-40 secs. then runs fine. looking through the forums point to computer, but i don't have the issues that point to it. I checked most of the grounds in engine compartment. Seems like i have a major draw when starting.
07-08-2010 06:11 PM
flatline 7-9 is to low. since it starts when jumped, I would check alternator output voltage. that should be around 14-15 volts. the battery should show a good 12 volts.
07-08-2010 02:14 PM
wrangler91blueballs
91 wrangler 4.0L hard start

I have 12v everywhere, replaced starter, plugs, cap, rotor. I got to start and feels like it has no juice. i cycle the key it will slowly turn over and crank and then it will start. If i jump it starts right away. That battery is good. On my volt gauge it shows about 7-9 volts. But by this time with age i don't worry about it.

Any idea's would be great. Someone said maybe the ignition switch on the steering column might be an issue.

it just started to happen in april and just now getting around to trying to fix it.


Thanks for looking

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 05:04 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC