|07-22-2010 11:38 PM|
I'd pass. Would probably cost you $600 to get all the brackets welded on, and then you either need spacer adapters or new wheels for another $100-$400 cost... plus the front axle is a Low Pinion. Plus 4.56's are not that much for 4cyls... especially if you plan on running 35's(?)... I'd get something with at least 4.88's or better yet 5.13's.
IMO - I'd only consider a HP front axle for swapping.
|07-22-2010 11:32 PM|
|07-22-2010 07:33 PM|
|MikalCarbine||I assume you are on a d35 rear and a 2.5L?|
|07-22-2010 07:11 PM|
|pakman55||The only reason I was thinking was becasue they were cheaper than getting it regeared and had the right gears. There is a guy on the forum who makes 8.8's cheaper tha ECGS. I'm not sure if I am even going to upgrade right now, I am looking to run 33's|
|07-22-2010 07:09 PM|
|4Jeepn||Don't forget you will new rims as the bolt pattern is 5 on 5.5. As for the kits the they run 300 to 400 based on fast serach. figure few hundred in labor as well.. Have you thought about swapping in a ford 8.8 and keeping the 30? Bolt In Axles - Complete Axle Assemblies - Axle Housings|
|07-22-2010 06:51 PM|
|pakman55||thanks for the info...i dont have access to a welder myself..How much do you think it would cost me to have somebody make it "bolt in" ready?|
|07-22-2010 06:47 PM|
|MikalCarbine||They'll require some cutting/welding to get them to bolt up to your jeep, that's all I can tell you|
|07-22-2010 06:42 PM|
Help with axels
Alright I found this on the local clubs sight...They seem good to go, pretty good price, correct gears, and I would spend more than that on a regear anyways. How much work would be required to install them?
frt lp d44 and d44 rear (NEW PRICE)