Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Do I need a slip yoke eliminator??

Join Wrangler Forum Today


Thread: Do I need a slip yoke eliminator?? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-04-2010 10:58 PM
cavediverjc Don't forget that you'll need adjustable rear upper control arms (if they didn't come with your RE lift) if you're going to install a SYE.
08-04-2010 10:51 PM
Ken Steele A transfer case lowering kit may eliminate the vibes, but an SYE is the best fix with a longer drive shaft. It is not overly difficult to install on your own. Advanced Adapters sells some high quality kits with detailed easy to follow instructions. If you have the mechanical know how to remove and reinstall the transfer case, then you should be good enough to install the kit. It seems much more intimidating than it really is.

Oh yeah, check your rear pinion angle also. Since installing your lift, it may be at a bad angle.
08-04-2010 10:46 PM
Jerry Bransford Your RE 3.5" lift is more like 4.5" in reality and my standard SYE and longer CV-driveshaft recommendation is that it is needed for 4" and taller suspension lift heights. Not only does that combination get rid of the vibrations, of course, the OE driveshaft starts becoming too short once you get to 4" of lift height. Should the OE driveshaft get pulled almost off the t-case output shaft due to it being barely long enough with that much lift, it can conceivably bend the t-case output shaft if it binds on the t-case output shaft as it tries to recompress after being pulled out from the suspension flexing fully.
08-04-2010 10:07 PM
TjTheo Did you lower the transfer case?
08-04-2010 10:02 PM
houstonwrangler
Do I need a slip yoke eliminator??

97' TJ with 3 1/2" Rubicon Express lift kit and Daystar 1" body lift, 35" BFG KM2's. Since the lift, I have had a pretty serious vibration at all speeds when accelerating. IF I do need a SYE, has anyone installed one on their own and how hard was it?? Any special tools required? Any recommendations on brands?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:17 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC