|08-05-2010 07:51 PM|
If you set the low pass, you'll get just as much bass as before (set it low enough and you'll get cleaner bass), BUT...then you'll be cutting most, if not all, the highs from the soundbar speakers. And considering the soundbar speakers produce most of the sound from our stereos, it'll sound like crap due to lacking the higher frequencies.
The best thing you can do with a factory sub setup would be to install crossovers in the wiring to the rear speakers (past the point where the line out converter for the sub is located) with a high pass at approx 80-120hz. That'll give you clean sound to the soundbar speakers. And then you could install a crossover with a low pass at 50-80hz in the wiring from the amp to the sub which will only send the low frequencies to the sub. I'm not exactly sure how you'd do that...I'm not a pro with crossovers, but that's about the only way to adjust the frequencies going to the rears on the factory setup. Not at all worth the time and money IMO.
|08-05-2010 02:11 PM|
|Ibuildembig||A factory setup with HPF? Never seen one....depending on your radio you can set the front speakers different from the rear speakers. I'd set the HPF on the fronts at 100Hz and leave the rears alone until you decide if you want a amp on the sub.|
|08-05-2010 01:02 PM|
|08-04-2010 11:56 AM|
For people reading this who don't understand crossovers etc here's a quick breakdown:
HPF: high pass filter (cuts all lower freqs out of your speakers at a point you set...usually 100hz and up)
LPF: low pass filter (cuts all higher freqs out of your speakers at a point you set...usually 100hz and down)
Basic scenerio that works....2 front speakers, 2 rear speakers powered by the head unit and a subbox powered by an amp. If your radio has built in crossovers for the speakers connected to it (not rca's), you can use the HPF to cut the lower freqs out of your 4 speakers since you have a sub to carry those.
|08-04-2010 11:07 AM|
|Jerry Bransford||I ended up setting my low-pass filter to 120 Hz. Any lower than that and my speakers started breaking up/distorting. I left the high-pass filter alone, you don't really need to worry about it.|
|08-04-2010 10:07 AM|
|Ibuildembig||What kinda radio is it? I set the Highpass on all the time for people, but only when a sub is present.|
|07-28-2010 10:23 PM|
|s3nt3nc3d||I don't think it'll make a difference as I think it'll only affect the signal going from the RCA's to the amp if you had one hooked up...errr actually high pass probably will affect the signal going to your speakers. I personally would disable both if possible. If you speakers sound fuzzy...change you high pass to 80hz or even 100-120ish and see if that cleans it up. What the low pass does is it only sends the frequencies below the set point to the subs...and the high pass sends the frequencies above the set point to the speakers. So when you set the high pass to say 80hz, it's only sending 80hz and above to the speakers. You will lose a little bass, but if the speakers can't cleanly play below 80hz, it'll make them sound more crisp and clean.|
|07-28-2010 07:52 PM|
High Pass Filter / Low Pass Filter Settings
So, I'm a bit of a neophyte when it comes to understanding all the setting on a radio, and the one I have has a couple settings for High Pass Filter and Low Pass Filter. Both range between 80Hz and 160Hz. Any thoughts on what these should be set at? At the moment I have Polk db521 rear speakers and factory fronts. The console sub has been disconnected, pending a replacement. It's blown and sounds horrible, so I just unplugged it for now.