|08-29-2010 03:39 AM|
It's my job to know these things.
|08-29-2010 03:11 AM|
You're learnin' me good coyote_94yj
|08-28-2010 09:13 PM|
|08-28-2010 01:37 PM|
|Coyote_94YJ||In your case Rover, I would just stick to the ATF. That is what is already in there and to change to a different fluid would involve rinsing out all the old ATF. Where is this smackdown taking place?|
|08-28-2010 10:42 AM|
Now what??? I bought the ATF...I also have 5 qts of Amsoil 80w90...a better choice? Synthetic I know...
Since I just went to the store and bought the ATF+4 that is where I'll begin...unless someone convinces me otherwise.
I'll also go check out the 'smackdown'....you know just to muddy my mind...lol
|08-28-2010 02:45 AM|
Well, the factory service manual for my 94 that I used to own said the transfer case uses ATF.
Here are a couple of reasons I ran straight gear oil in the transfer case.
1) It isn't going to do any damage. It will make it harder to shift on the fly but I don't do that anyways.
2) It is thicker and is less likely to leak.
3) Why carry a whole bunch of different bottles of fluid on the trail. The axles and transmission I had used gear oil so why not in the transfer case as well.
Just my personal opinions and experience but I've been into my transfer case a number of times over the years and the gear oil has worked just fine.
|08-28-2010 02:29 AM|
Please coyote_94yj ! Explain running 90wt in the transfer case!
I'm not convinced running ATF is the correct solution for a 91 Jeep 2.5L.
|08-28-2010 02:14 AM|
|Coyote_94YJ||Yup, ATF+4 is what the book says but I've ran 90wt in my case for 10 years with zero issues.|
|08-28-2010 02:03 AM|
Don't thank me Rover, there's a board "smack down" going on right now about your question.
I've given you the O.E.M. info. Cheers!
|08-28-2010 01:56 AM|
|Rover||That is what I thought I'd read...thanks FNJ|
|08-28-2010 12:48 AM|
|FNjeep||The quick answer is 2 Quarts of ATF+4.|
|08-28-2010 12:23 AM|
Transfer case fluid
Just to be sure...I have a '91 Wrangler 2.5 5 speed...
The fluid in the transfer case is ATF+4....??? Is this correct.
Does anyone know the capacity? A quart or two?