Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > towing ?'s

Join Wrangler Forum Today


Thread: towing ?'s Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-08-2010 01:34 PM
yj-genral oh and you will need to regear that beast to help out on the trail and the road. its doable without it but its like driving with street tires or mud tires off road... there is a big difference. and the regearing will allow you to get back to stock performance therefore letting you tow what you want again.
09-08-2010 01:32 PM
yj-genral also another good point is that a lift of 3-4" or more of lift the lift manufactures recommend new driveshafts but its not a requirement. its more common with the previous jeeps with ujoint driveshafts, the newer CV joint driveshafts dont have as much of an issue but i would still recommend new ones with 4" of lift because of 3 reasons
1) rubbage with the stocker and the boot
2) alot of the slip is gone on droop because its almost fully extended sitting still
3) angles/strength, new angles are harsher on the joints (cardian joints helps this) aftermarket shafts are smaller in diameter and much much stronger.
09-08-2010 12:57 PM
daggo66 Here's an article in JP Magazine that explains the issue: Fatal Angle Tom Woods JK Wrangler Driveshafts - Jp Magazine
09-08-2010 12:30 PM
GREEN-MACHINE anything more than 3 inches and then you talking drive shafts and pinion angles. i have the teraflex 3 inch and could not be happier it also has sway bar disconnect. 35 inch tires will fit just fine. as far as gearing use this link.Gear Calculator
09-08-2010 12:07 PM
daggo66 It is a well known and documented fact that the CV boot will rub and tear with a 4" or greater lift. It is much more likely with that lift and an automatic transmission on a 2 dr.
09-08-2010 12:03 PM
JeepJK10 I didn't think I would hve any problems with that the driveshaft but I'm no expert. Anyway I am still wandering about towing the Seadoos right now it alittle slugish and I'm affraid if I go up in tire size I will be stuck going back and forth between 4th and 5th gears.
09-08-2010 09:14 AM
Droelle Oh. Well I'm not really into crawling a whole lot. I live in east Texas. Lol all we have is mudd. The flexing part might make you have to have longer drive shafts. But if you read up at the top of the the jk forum first page where all the different threads are they have the lift kit reviews. And from all the one that I have read none of them really had a driveline issue or mods with a 4" lift. Just some longer brake lines. I plan to go with a 3.5" or a 4" lift. As far as me doing any driveshaft mods... not unless I have to. Second I've never heard of 35's fitting under a 2.5" lift? Not saying its not true just never heard of it.
09-08-2010 08:18 AM
JeepJK10 Ok thanks
09-08-2010 08:08 AM
daggo66 You are going to have driveshaft issues with a 2 door and a 4" lift, especially if it's an automatic. You can run 35's with a 2.5" lift. Also if you want flex, you should be looking at sway bar discconnects.

If you are going with 4" be prepared to spend some $ up front to do it the right way or you will be sorry down the road.
09-08-2010 07:56 AM
JeepJK10 Thanks let me know what you find out. I will try to dig alittle more too and get back with you.
09-08-2010 07:49 AM
Droelle From what I was told from other forums gearing will help out alot. If your running a automatic 4.88 gears with 35's. If its a standard 4.10 gears running 35's. I to own a sport. Its a standard and I'm also in the process of trying to figure all this out.
09-08-2010 07:47 AM
JeepJK10 2dr
09-08-2010 07:22 AM
daggo66
Quote:
Originally Posted by JeepJK10 View Post
That's a good point. My brother and I are going to start doing some jamborees. I am aslo going with a 4in lift but I don't want the tires to look small but I also want some flex.
Do you have a 2dr or 4dr?
09-08-2010 07:07 AM
JeepJK10 That's a good point. My brother and I are going to start doing some jamborees. I am aslo going with a 4in lift but I don't want the tires to look small but I also want some flex.
09-08-2010 06:53 AM
daggo66 what kind of trails are you riding? 35's are not a requirement for driving off road.
09-08-2010 06:49 AM
JeepJK10
towing ?'s

I have a 2010 jk sport I would like to run 35's but I know that my gearing won't let me tow my two Seadoos (about 2000lbs on the trailer) with that tire size. I like to do some trail riding also!! What would anyone suggest for my situation.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:31 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC