|09-14-2010 11:57 AM|
And what you said about winch and recovery gear is good advice too. I would add to that a Pull-Pal. Being a boy scout, I just like being prepared for contingencies.
|09-14-2010 11:53 AM|
If I had to make a list on what I would like to be getting first it would go:
2. 2" lift
3. Winch/ RuggedRidge XHD Bumper
After that I'd probably go with some body armor.
|09-14-2010 11:51 AM|
Thing is, if you buy tires before you lift, then you just have to buy new tires....
|09-14-2010 11:48 AM|
Or maybe tires...
or you could go all out and go for... tires.
I've plugged two tires on my JK already, and I haven't gone wheeling for the sake of wheeling at all, just out trying to get to the good fishing spots... I'd replace those sport tires before going for skids or a lift.
|09-14-2010 11:46 AM|
|09-14-2010 11:44 AM|
I would suggest the following three, in this order.
1) Winch (& recovery gear)
2) Suspension & tires
3 Skids and rock rails
The reason I put skids after suspension is because certain skids require specific clearance.
I'm still running factory skids though...
One really big piece of advice, if you don't mind, is to really think forward on the mods that you do. Try to avoid impulse purchases without looking at the long range effect it will have on the future build of your vehicle.
All of the little bling bling stuff will eventually turn out to be a waste of money and get taken off and tossed into a pile in the back of the garage.
Armor, armor, armor.... very important stuff.
Avoid "Tube" bumpers, they're worthless and the subject of much ridicule.
|09-14-2010 11:25 AM|
Welcome to the club.
I've also gone through Quadratech's magazine and circled everything I would like to have. Total comes to $4255 + tax
|09-14-2010 12:02 AM|
|Jkw||Welcome good luck|
|09-13-2010 11:07 PM|
|Serge A. Storms||Hell, I left my Harley in Detroit to drive my Jeep home to CA!|
|09-13-2010 05:08 PM|
|E.Richardson||Thank you to everyone for the great suggestions. Skid plate seems to be the overwhelming response from everyone. I'm going to start searching today. This forum and its members have been awesome to talk with!|
|09-11-2010 11:57 PM|
|09-11-2010 11:42 PM|
|InfernoGirl||Just Empty Every Pocket...... Welcome to the addiction!|
|09-11-2010 10:39 PM|
|iamagolfspaz||Personally I would do an Oil pan skid first. Bust that and your not driving out.|
|09-11-2010 03:59 PM|
Well if you plan on wheeling the Jeep at all start from the ground up. First thing on your list shoud def be an "evap can" skid. If you break or damage the unit underneath the Jeep it will throw codes and a check engine light. Its a small easy to install skid plate.
You'll figure out the things you need opposed to the things you want as you go.
Good Luck with it!
|09-11-2010 03:16 PM|
i sold my harley to mod the jeep. start at the bottom and go up. i did lift kit. ox locker. kc lights. switch panel. and a bunch of armor under the jeep, diff covers/ e-vap. bla bla bla.
DAMM jeeping in expensive.
|09-11-2010 02:01 PM|
I know how you feel. I haven't been riding my Harley as much as I used to since getting my Jeep almost a year ago. Nice days I rather drive the Jeep with doors/roof off.
As to your question I guess it's all up to the amount of money you want to spend at one time. I'd say lift, wheels, & tires first
|09-11-2010 01:57 PM|
This habit will be worse than my Harley
So I've had my Sport now for 48-hours... I cannot believe how many things I've circled in the accessories magazines that I've collected. Question is, do I start from bottom up (suspension, etc.) or do I work from the outside in? I guess it's all personal preference, but any insight (if needed) would be helpful.