Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK Tech Forum > Dynomax® Ultra Flo Evolution Competition Cat-Back Exhaust in Stainless Steel

Join Wrangler Forum Today


Thread: Dynomax® Ultra Flo Evolution Competition Cat-Back Exhaust in Stainless Steel Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-28-2014 09:05 PM
JCDriller Got the new mid pipe installed today. It didn't go perfectly smooth, but I got it in with a little work. I still had to cut about 1/2" off the mid pipe as the rear exhaust mount that attached to the turn down wouldn't reach even when rotated horizontally. Cutting 1/2" off the mid pipe helped but then I was in contact with the cross member again. Next move was to cut a wedge out of the exhaust turn down clamp so that the turn down would seat deeper into the muffler allowing me to attach the rubber mount. This finally worked.

If I could do it again, I don't think cutting the mid pipe was needed, I think I could have got it to fit by just cutting the clamp. Either way, it's all assembled, not in contact with the body and sounds great.

Shows how close is it to the cross member


Shows the rubber exhaust mount sitting horizontal and the cut I had to make to the clamp to allow me to push the turn down further into the muffler and attach the exhaust mount.
03-28-2014 06:54 PM
pbeachcruzer does this system tuck up higher than stock to aid in suspension travel?
03-28-2014 12:41 PM
JCDriller My new Midpipe showed up yesterday, big props to DynoMax for sending it out so quickly. I'll try and get it installed today after work if the rain holds out.
03-24-2014 07:08 PM
DynoMax Exhaust All stainless 409 or 304. As stated no cut on the 3.6 JKU !!!!
03-24-2014 06:58 PM
JCDriller
Quote:
Originally Posted by Old Dogger View Post
Now that is a good sounding system!

It also, helps to eliminate that horrid V6 DRONE SOUND!!!!!
I'm VERY impressed with the customer service! The exhaust does have a slight drone at 1500 rpm, but for me that's 25 and 45mph depending on the gear (auto/3.21). I find myself just driving 5 over and the drone goes away. At highway speed it's almost non existent. I think it'll be even less noticeable when I swap to 4.88s as I should stay above 1500RPMs most of the time.

Don't let this stop you, this exhaust sounds great for a V6 and it's very light and tucked out of the way. Plus it's only $130 from Amazon after your rebate! I've also picked up ~1.4 MPGs city since putting the exhaust on, I feel like I'm even revving it more to enjoy the sound.

I have been checking my Evap for heat, I plan on relocating it anyway, but so far I don't think it's a requirement as it doesn't seem to be getting warm, even after longer drives. That being said the temp hasn't been above 80* yet to really test it out. Just keep in mind it dumps next to the evap, so keep an eye on it.

Please let this be a warning to all: DON'T cut your pipe on a JKU 3.6 even though the instructions tell you too.



Dynomax, The pipe, hangers and muffler all hold a magnet. I realize some stainless is magnetic, but I'm curious are the pipe, hangers and clamps all stainless or is it just the muffler?

Thanks again!
03-24-2014 05:03 PM
scoutermike
Quote:
Originally Posted by DynoMax Exhaust View Post
Got your PM, I will get you a new pipe out.
What year by chance on your JKU?
The cut is NOT needed on the 4 doors.

Too bad Magnaflow wasn't this good with it's customers! I should have gone with Dynomax.
03-24-2014 02:12 PM
Old Dogger
Quote:
Originally Posted by DynoMax Exhaust View Post
Now that is a good sounding system!

It also, helps to eliminate that horrid V6 DRONE SOUND!!!!!
03-24-2014 11:57 AM
kjeeper10 CS at its finest right there ^
03-24-2014 11:20 AM
DynoMax Exhaust Got your PM, I will get you a new pipe out.
What year by chance on your JKU?
The cut is NOT needed on the 4 doors.
03-22-2014 09:20 PM
JCDriller So I installed this exhaust today, the rubber exhaust mounts suck, but with a long strong screw drive and some PB blaster I had them off in about 20 minutes. I cut the 2.5" off just like Dynomax says which I had to go purchase a sawzall for since the hack saw wasn't cutting it, that really should be taken care of at the factory. I'd spend an extra 10 for a system that was already cut so I wouldn't have to dick with it and purchase a 100 tool, although I'm sure it'll be needed and get used again.

Everything went well until I tried to mount it up. It went to place, but the front lip of the exhaust hits the cross member that is below the drivers seat so the exhaust isn't hanging free from the rubber exhaust isolators. Whats going on here?

Exhaust sounds great, nice and throaty at full acceleration with just slight drone that is barely noticeable at 70 and I'm sure would be drowned out by the howl of MTs if I was equipped. So far I'm very please, but I have to figure out how to separate the cross member and the muffler...

03-19-2014 10:17 PM
DynoMax Exhaust
Quote:
Originally Posted by JCDriller View Post
Why is this an off road only exhaust?

Some states require an exhaust system to exit out the rear of the vehicle.

03-19-2014 08:05 PM
JCDriller Why is this an off road only exhaust?
01-28-2014 12:00 PM
DynoMax Exhaust Sound clip!!!!
Pretty spot on.

Project-JK 2012 Jeep JK Wrangler DynoMax Evolution Competition Exhaust System Sound Clips - YouTube


01-27-2014 09:07 PM
907JEEP
Quote:
Originally Posted by Hieneken49 View Post
sound clips when its on!
X2 please
01-27-2014 08:56 PM
Hieneken49 sound clips when its on!
01-27-2014 08:30 PM
907JEEP
Quote:
Originally Posted by tabber02 View Post
dynomax is a vendor on the WF, PM them...
Oh ya. I forgot that. Thanks
01-27-2014 08:29 PM
907JEEP
Quote:
Originally Posted by ThomasJKU View Post
You do not have to cut 2 1/2 inches off for an unlimited. I installed this system on my 2013 and it fits like a glove straight out the box.
Ok hows the sound ? I dont want my jk sounding like a tuner
01-27-2014 07:57 PM
ThomasJKU You do not have to cut 2 1/2 inches off for an unlimited. I installed this system on my 2013 and it fits like a glove straight out the box.
01-27-2014 07:30 PM
tabber02 dynomax is a vendor on the WF, PM them...
01-27-2014 04:35 PM
907JEEP Im looking at ordering this exhaust for my 2014 JKU and i was wondering as to why the install instructions say to cut off 2 1/2 inches. Why doesn't the system come ready to install? Its either this system or the Dynomax rock crawler cat back system. I cannot really decide between the 2 systems. Whats everyones opinion?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:16 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC