Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Blower Motor Resistor Problem

Join Wrangler Forum Today

Thread: Blower Motor Resistor Problem Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-07-2010 02:20 AM
NAVYCHIEF 55035958 is the correct mopar number
10-07-2010 01:11 AM
kmobrien76 same thing going on with my jeep, what did you end up doing to correct it?

01-13-2009 08:58 PM
ecsjr I'll check the wires for breaks/shorts.

Is there a way of checking the part number? The new one is #55035958.
01-12-2009 10:45 PM
jpdocdave possibly wrong or bad part. it shouldn't have been different. i have seen a couple instances where blower motors would fry resistors. also shorts, or poor grounds.
01-12-2009 10:33 PM
Blower Motor Resistor Problem

My 95 Sahara heats up great in the winter- lined Hard Top and full doors. But the Blower motor is a High Speed or No-Speed deal.

After searching here, I figured the problem was the Blower Resistor. So I replaced it and I had all three speeds of the Blower Motor. Great!

Problem is, I only had all three speeds for about an hour, and then back to High Speed or No-Speed. What would kill the Resistor so fast? Could they have given me the wrong part? ( The new Resistor was only $5 from the dealer, but everyone here suggested it would be about $20.) The screws holes were a little off and the part number was different than the old one.

Any Ideas? Could something be frying my resistors?

Thanks for any help

'95 YJ

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 10:21 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC