|10-29-2010 12:31 PM|
These are Pro Comp 32x11.50x15's and Yes they rub in a very tight turn with no lift. But I like them and they go where I point them. So far no damage and I do not treat them well.
As seen here lol
|10-29-2010 12:16 PM|
|AdrenalineJunky45||Im running 33 cooper stt's with a 1 1/2 in teraflex coil spacer nch right now and mine rub on the sway bar only when i turn real sharp......|
|10-29-2010 11:40 AM|
|10-29-2010 11:31 AM|
|InfernoGirl||Washers on the steering stops are much safer than spacers.... Especially the half inch spacers you are referring to, if I'm correct in my assumption.|
|10-29-2010 10:41 AM|
|Britanbradford||Or if you don't want to risk using washers, you can buy 1/2 spacers. You'll only need two and they run about $50|
|10-29-2010 10:38 AM|
|s3nt3nc3d||31's sometimes rub and sometimes don't...but those that rub can be very quickly and easily fixed adding the washers as mentioned above. Extremely fast and simple fix. smin41, I'd recommend going with 31's.|
|10-29-2010 10:34 AM|
|smin41||I have a stock wrangler with no lift, what is the largest size tire I can get without rubbing? Someone told me 30's will not rub.|
|10-28-2010 07:00 AM|
|Atthehop||Washers are cheaper.|
|10-28-2010 04:36 AM|
|jeepjones||Why don't you get some wheels with 3.75-4.00" backspacing.|
|10-28-2010 12:15 AM|
Usually takes two..depends on the thickness of the washer.
You will have one on both sides "knuckles"...do both.
And yes...that simple.
|10-28-2010 12:14 AM|
|Red Wrangler||so i just pull it off on both sides and throw a washer on there?|
|10-28-2010 12:11 AM|
They limit the radius of turning.
|10-28-2010 12:03 AM|
|Red Wrangler||i have absolutely no idea what the steering stop bolt is or where it is. ha|
|10-28-2010 12:00 AM|
Most likely rubbing on the lower control arms.
Easy fix. Place a washer or two behind the steering stop bolt ....fixed.
|10-27-2010 11:58 PM|
so i just got some 31" BFGoodrich A/T not too long ago and i notice when i turn the wheel all the way to either side, they rub. i think theyre rubbing against the frame but im not completely sure. i havent rubbed them since i noticed that it does that. and i dont have a lift or anything. what can i do to stop the rubbing that isnt expensive? and i dont want to lift it quite yet. i just want that killer turn radius back. haha