Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > 2" Lift Questions

Join Wrangler Forum Today


Thread: 2" Lift Questions Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-31-2007 12:12 AM
upinar u dont need any special tools to do a lift. Just disconnect the sway bar, and tracbar and let the axle droop to the floor. Stock springs fall right out. I put in my 4 inch springs with 2 inch spacers, and everything slipped in, then put a jack under the differential and raise the axle and bolt everything back up. Basic sockets and wrenches can get the job done. Oh, and some jack stands and a big jack
05-30-2007 11:56 PM
hazmat
Quote:
Originally Posted by gcdcpakmbs View Post
I'm towards the end of a 2" lift. '06 "X" SWB. My rear axle and front both moved about 1/2" (opposite directions).

I don't have a clue as to how much that affects your ride. But I installed adj track bars. One more round of adj and I ought to be dead-nuts on.
who's trac bar and can you re use them when you go to a bigger lift
05-30-2007 10:36 PM
mrbigjeep front isn't bad...its the rear axle thats noticeably uncentered...

you don't need the compressors if you use the bottle jack...trust me...i put on the lift.
05-30-2007 11:48 AM
gcdcpakmbs I'm towards the end of a 2" lift. '06 "X" SWB. My rear axle and front both moved about 1/2" (opposite directions).

I don't have a clue as to how much that affects your ride. But I installed adj track bars. One more round of adj and I ought to be dead-nuts on.
05-30-2007 09:05 AM
DocG2828 I did a 2" lift and my front is aligned just fine. My back is a little off though. I've never measured it, but I'd guess its off about an inch. I've been debating the rear trac bar relocation bracket but I'm not sure how much that will change it, and if it will change it too much the other way.

For now I ride around a bit crooked, doesn't seem to cause any major problems.
05-30-2007 01:18 AM
Joe Dirt It will sit fairly centered with such a small lift. Don't worry about it unless you go taller.
05-30-2007 12:52 AM
Sahara97
Quote:
Originally Posted by Sahara97 View Post
How is the front? Does it align side to side with the 2" springs on it?
With the stock track bar in the front does the axle sit centered on the chassis or is going to be pulled to the one side?
05-30-2007 12:19 AM
Joe Dirt Trust me. I tried it without the spring compressors when I had a 2" and you want the compressors. Afterwards you will need an alignment. Autozone does a free rental. You deposit the full cost and get it all back if you return them, or you can keep them for the deposit price. Good luck.
05-29-2007 10:04 PM
Sahara97
Quote:
Originally Posted by bigjeep View Post
you can use a bottle jack between axle and frame to get springs out.

chances are that your axle will be a little off center.

i have a 2" coil lift and my rear axle isn't centered perfectly...i can tell it sticks out farther on one side...no big deal though
How is the front? Does it align side to side with the 2" springs on it?
05-29-2007 07:38 AM
mrbigjeep you can use a bottle jack between axle and frame to get springs out.

chances are that your axle will be a little off center.

i have a 2" coil lift and my rear axle isn't centered perfectly...i can tell it sticks out farther on one side...no big deal though
05-29-2007 05:39 AM
debruins i think that autozone rents spring compressors for like $5 I would try a place like that first, then your not messing with all of that

and yes there's a chance, but i've never heard of it so its very slim, otoh all jeeps are differenet and it would suck to fid out you actaully do need it after you get home
05-29-2007 02:17 AM
Sahara97
Quote:
Originally Posted by Joe Dirt View Post
Spend $30 for a set of spring compressors (or better yet, borrow some). It will save you time and busted knuckles, well worth $30. Also get shocks that are valved for a Jeep. Its not just 2" longer shocks. Shocks valved for a truck or something heavy will make the Jeep ride like crap.
I heard that you can use a lift to take the springs out. You just unbolt everything and then lift up the whole jeep and then put the new ones in. Is this true? I've been looking at a set up trac bars for it on ebay and ones going to ship them to my parents house in PA when I fly home and then put them in my luggage so that I'll save about 100.00 in shipping. Is there any chance that my stock track bars won't allow the axles to be centered?
05-28-2007 11:16 PM
Joe Dirt Spend $30 for a set of spring compressors (or better yet, borrow some). It will save you time and busted knuckles, well worth $30. Also get shocks that are valved for a Jeep. Its not just 2" longer shocks. Shocks valved for a truck or something heavy will make the Jeep ride like crap.
05-28-2007 04:54 PM
debruins nope just springs and shocks, if you find that you have vibes or something else that isnt right come back here and ask, and we will be able to tell you what you will need. there are plenty of people that only run BB's and new shock so i dont see why new springs instead of BB's would be different
05-28-2007 04:40 PM
Sahara97
2" Lift Questions

I am getting ready to put a 2" lift on my Jeep. I want to go bigger but the recon is a b%^& here in Hawaii where I am stationed. But my questions are I got the springs and shocks, do I need track bars for the front and rear with the 2" lift. And if anyone knows anything else that I am going to need to complete it let me know too.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:36 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC