Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > 97 TJ wont start after using charger starter

Join Wrangler Forum Today


Thread: 97 TJ wont start after using charger starter Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-24-2006 08:51 AM
JeepCrawler98 The coil isn't going to get a constant voltage - it's going to work in short pulses as the ground is switched on and off pretty rapidly by the PCM. What you need to do is put a test light on the terminals coming out of the connector, and have someone crank the key. If the light flashes briefly and at regular intervals; chances are the coil is bad and should be replaced.
02-24-2006 08:03 AM
Tom Van Horn
97 TJ wont start after using charger starter

My 97 TJ had been sitting for a few weeks and wouldn't turn over. I put my charger on it and try the start position. It would only click the starter. I let it charge on trickle for the night and still wouldn't start in the morning. Put a new battery in and it would spin over just fine but wouldn't start. Check to see if I was getting spark at the spark plugs. Didn't see any.
Pull the distributer off and cleaned it up. No change. Check the voltage with the key switch in the run position going to the little black box that feeds the distributer center post. No voltage. Where do I go from here?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:28 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC