|11-29-2010 12:22 AM|
All I did was use the block of wood and jack method...I did it alone and nearly ripped my arm off doing a one handed door catch when it suddenly broke loose and popped out. Definitely have a buddy help you. One person to hold the door (window down...then hold it via the window frame) and one person to slowly crank the jack up (position it as close to the hinges as possible).
Once I had them off, I took a scotchbrite pad and cleaned the rust off the pins...then took some all-purpose grease like is used in a standard grease gun and just smeared it on the hinges and put a pump down inside each hinge. Then put the doors back on, wiped all the excess grease off with a rag and swung them back and forth a bit to work the grease in good. Now they lift right out (I neutered mine...removed the nuts and cut the threads off the pins).
|11-29-2010 12:08 AM|
|harleytj||Use a SMALL amount.|
|11-27-2010 11:14 AM|
|Atthehop||Anti Seize. Any auto parts store has it. It's something you cannot live without.|
|11-27-2010 11:01 AM|
|bmori||what type of lube or grease do you use on the door hinges?|
|09-02-2010 10:29 AM|
The wood & jack method works fine, no issues, just make sure use use a 2x4 or 4x4 long enough so you don't hit the bottom of the door. Also for extra safety, put towel or blanket along side if worried the wood might slip and hit the jeep.
Just remember move the jack slowly, since hinge pin is tight, you don't want it just flying out. Like Inferno said, grease or lube the hinge pin and hinge plate on Jeep and work door back & forth when putting back on.
|09-02-2010 09:47 AM|
|InfernoGirl||And remember to grease the pins before you reinstall the doors. I forgot to grease the pins on the door we ended up having to pry out with a prybar.... It was almost as hard the second time to get it out......|
|09-01-2010 02:57 PM|
|Neil F.||It's not going top crumple the door. I did it that way the first time as have lots of others.|
|09-01-2010 02:31 PM|
It's a method I've heard works, but I've never tried it myself since I got mine new. I did have to wiggle the passenger door back and forth while lifting up on it since when I first removed them it hadn't been used much, so the insert wasn't worn down yet. Now it's a cinch.
If you do use the block of wood method, there is the disclaimer to not do it like your jacking your Jeep to change a tire. You've got to pay attention.
|09-01-2010 02:18 PM|
|Gee oh Dee||
I wouldn't use a jack and block of wood either. That'll easily crunch the bottom of your door.
Hit it with some PB blaster, and work the door open and closed a bunch while putting gentle upward pressure on the door.
Others have said the door needs to be near closed to easily slip out of the hinges.
|09-01-2010 02:08 PM|
Ah! Don't beat them with a hammer. They are attached to the door. Just lift up on the door.
If it's stuck you can use a block of wood and a jack under the door when it's open to get it unstuck. Just make sure you have a couple peope to help if you go this route. Don't want to have your doors come out suddenly and end up on the concrete.
|09-01-2010 02:06 PM|
I took off the nuts but how do you get the hinge pins out. I tryed beating them out with a hammer but I don't want to f anything up.