Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Thinkin' about a winch -- feedback please

Join Wrangler Forum Today


Thread: Thinkin' about a winch -- feedback please Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-01-2012 09:10 AM
Jervboy Winches. Check this thread out.
http://www.wranglerforum.com/f123/en...ml#post2424686
06-01-2012 08:19 AM
norski74 I used the rough country mounting system. You take the bumper off remove the stock tow hooks, put on there threaded replacements. The back mounts bolt in on the passenger side. The drivers side on a 2012 has a air can sensor mount that has to be removed, a 4 inch grinder an a cut off wheel works well. I adapted it to there winch mount. A couple tack welds will do for holding it on. Bring the bolts close to being tight. Put the bumper back on tightening the bumper bolts . Put the plate on and bolt it to the mount. Tighten the rear mounts. Then your ready for what ever winch you want. The only winch that will not mount direct is a 8274 warn. I made a mounting plate for mine. Cut the vertical part of there plate off an welded my mount to there's. Hope this helps ken
05-31-2012 11:18 PM
Sinz I just bought my first winch ever and I got the Warn 9.5 CTI-S because you hear nothing but great reviews on them, reliability & high quality, sure I spent a lot for it but it's the only winch that will last me for a very long time and later down the road when I get a newer Jeep I will be switching it over there...Do it once & do it right!
05-31-2012 11:09 PM
Duffyc04
Quote:
Originally Posted by castorj29
Go Warn............cost more,but you wont be dissapointed
X2. I have the warn m8000-s and it's fantastic, and the syn line keeps weight down..,I have it mounted on the warn elite bumper...it's a very high quality stuff.
05-31-2012 10:04 PM
snochick In all honesty, for the average Jeeper, you don't use your winch all that often. I had a MileMarker on my old TJ and it did just fine. I actually made it work pretty hard a few times b/c my brother was mudding in the Florida Swamps with a bit too much liquid courage in his Dodge Pickup.

Want a funny picture in your head, imagine a TJ trying to winch out a full sized truck buried to the frame with an angry alligator about 6 feet from the Jeep so I wasn't willing to get out more than once to throw the cable to his dumb butt.

I'm not spending a lot of money on winches this time around either. I just don't use it often enough to justify it. If I was doing something more extreme I might have a different opinion, but they are daily driver's so we do have to use some common sense when playing.
05-31-2012 09:40 PM
HAFICON Im just going to go with the Ruggid Ridge 10,500lb it is 399.00 But you can not beat a Warn. I had a 9500HSi that was moved from Jeep to Jeep then Tacoma then back to a Jeep again over about 12 Years. I did rebuild the gear box one time, it never let me down but for the cash IDK, because over the 12 years or so I might of used it 10 times. So I am going to go a cheaper route and get what I am sure is a decent winch, I just cant see spending that much money for something I will hopefully never use that much.
05-31-2012 09:27 PM
lindolyn13 Has anyone done a comparision on winches and what is the best for the money? I have searched the forums and have found nothing really helpful. I am not creating a rock crawler yet would like to do decent trails with some decent equipment on my jeep
04-07-2012 06:02 AM
Jervboy Here's mine.
12-03-2010 03:47 PM
h2otoo I will let someone who knows more than me chime in on that one. I went with the PEC after reading what reviews I could find on it. Had it just over a year now. Use it mostly to skid logs from the back yard to where I cut them up. (Although its first use was to get me out of a snow bank/drainage ditch). No complaints yet with the winch. (Don't ask about the wench )

Bob
12-03-2010 02:55 PM
J_Westy
Quote:
Originally Posted by h2otoo View Post
Brad, it is a Mile Marker PEC 8. I was going to go with Ramsey, but the savings on the MM was too good to pass up. The mounting plate is from Rough Country. Others make ones that work with the stock bumper also. I did lose the tow hooks and got D rings in place. Here is the link to their site, you can check out the install instructions:

Jeep JK Winch Mount

Bob
Which is better -- the PEC8 (Permanent magnet) or the SEC8 (Series wound)? They're pretty close in price, so which one?
12-03-2010 02:07 PM
h2otoo Brad, it is a Mile Marker PEC 8. I was going to go with Ramsey, but the savings on the MM was too good to pass up. The mounting plate is from Rough Country. Others make ones that work with the stock bumper also. I did lose the tow hooks and got D rings in place. Here is the link to their site, you can check out the install instructions:

Jeep JK Winch Mount

Bob
12-03-2010 08:18 AM
mortisdraco Bob, which winch is that and did you need to do anything other then add a mounting plate to the existing stock bumper?

thanks,
Brad

Quote:
Originally Posted by h2otoo View Post
Mac, no you do not have to change the bumper. Several companies make mounting plates for the stock one.

Attachment 31362

Bob
12-03-2010 08:15 AM
Wally Meyers My son used to married to a winch, or maybe it was a wench.
12-03-2010 08:02 AM
castorj29 Go Warn............cost more,but you wont be dissapointed
12-03-2010 06:15 AM
daggo66
Quote:
Originally Posted by rics1997 View Post
If your worried about the weight and still want to be close to stock, I checked with my dealer and stiffer coil springs were actually pretty cheap. I have 15's under mine and they quoted the 18's for $53 each and $85 to put both of them in. I am planning on getting them the first of the year. Getting a new winch and XHD bumper put on tomorrow. I can't wait.
You can can actually get 19's which are the tallest/stiffest and put them in yourself under an hour if you have a good set of jackstands.
12-03-2010 03:37 AM
Macnerd Thanks Bob! Great setup!!
12-03-2010 02:17 AM
h2otoo Mac, no you do not have to change the bumper. Several companies make mounting plates for the stock one.

Attachment 31362

Bob
12-03-2010 01:39 AM
Macnerd Thanks for posting this. I need to do some searching in the other threads. My 11 JKU Sahara doesn't have a bumper that looks like its ready for a winch. Do I need to replace the whole thing?
12-03-2010 01:27 AM
Sierra8 As far as a decent winch for a good price I've really liked my smittybuilt xrc8. Got it for 300 bucks including shipping and its worked or great. Doesn't seem cheap or under engineered.
12-02-2010 08:32 AM
rics1997 If your worried about the weight and still want to be close to stock, I checked with my dealer and stiffer coil springs were actually pretty cheap. I have 15's under mine and they quoted the 18's for $53 each and $85 to put both of them in. I am planning on getting them the first of the year. Getting a new winch and XHD bumper put on tomorrow. I can't wait.
12-02-2010 07:57 AM
h2otoo I kept the stock bumper. Weight and $$$ were part of the decision to go that route, although not the only factors. I do like the "in the bumper" look, but happy with what I got. I got the MMarker PEC 8 with a Rough Country mount. Got it this time last year (is that an oxymoron?). Happy with what I got and what I spent.

Bob
12-02-2010 07:49 AM
jonwild Yeah, someone help! I want to do the same thing (although I would go for a new bumper)...
12-02-2010 07:38 AM
J_Westy Gotta' be some wisdom out there?

ttt
11-30-2010 03:58 PM
J_Westy
Thinkin' about a winch -- feedback please

So I've been thinking about adding a winch to the Jeep and would appreciate some advice/feedback, pros/cons.

I don't anticipate doing any rock crawling, but definitely some trail / overland use a few times a year.

I like this concept using the stock bumper... kind of goes along with my "stealth" mods so far, plus it won't break the bank. I believe this owner used some spacers to get the fairlead out in front of the bumper cover for an extra clean install.




From what I've read, you use a universal TJ mount slotted to fit on top of the frame rails behind the bumper, mount your winch upside-down and slot your bumper cover accordingly.


Mount example - $30 from Harbor Freight:

Universal Channel Winch Mount




Winch example
- $297 Mile-maker SEC8 (8000 lb):

SEC8; Electric Winch-RH3





Fairlead Cover - $19 (to keep the Michigan winter crud out a little bit):

Mile Marker Roller Fairlead Cover - Winch Fairlead Cover - Winch Accessories - Winches and Winch Accessories - by 4 Wheel Parts-RH3


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:21 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC