Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   Help disassembling column (http://www.wranglerforum.com/f218/help-disassembling-column-105095.html)

Mastiff 07-31-2011 11:07 AM

Help disassembling column
 
I'm trying to help a neighbor replace the electrical guts in his column: the turn signal cam stuff and the mechanism at the end of the signal stalk. We got it to a point where it really seems like this upper plastic shroud should be removable, but it just won't come off. I'm looking for any pointers on what to do next. The upper plastic part is attach to the rest, and all the plastic seems only to be held on by the actuator rods for the ignition and turn signals. Here's a pic.

https://lh4.googleusercontent.com/-E...7-33-29_69.jpg

stimpy 07-31-2011 11:18 AM

Haynes manual chapter 12. They got pics of how to do it on page 12-9

lakey 07-31-2011 11:24 AM

we tried that chapter however it says to just pull them apart and that does not work

jfbilbro 07-31-2011 06:15 PM

dude, you got the column disassembled enough to replace the turn signal switch and the wiper switch....all you have to do is feed the wires thru the colmn to the plug in at the bottom.. easiest way is to clip off the old switches and tape the wiring for the new ones to the old wires and fish them out the bottom and then plug them in......:thumb:

2xs 07-31-2011 06:26 PM

Your friend has a post allready, look for my reply near the end, basically you dont have to go any further...

http://www.wranglerforum.com/f8/need...al-105068.html


All times are GMT -5. The time now is 07:27 AM.