Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   YJ windshield replacement (http://www.wranglerforum.com/f218/yj-windshield-replacement-10735.html)

ryobi 08-21-2007 11:04 AM

YJ windshield replacement
 
I am looking to replace my cracked, pitted, and yellowed windshield.

Who has the best prices on replacement windshields?

Also, anyone who has replaced a windshield before....

Any tips/pointers/advice/warnings?

skeeter 08-21-2007 07:05 PM

We just replaced mine a couple months ago.
We checked actual glass places and were getting quotes upto $350 to replace it. that was insane.
We then went to the local wrecking yard to see if they had a used one. Turns out they stocked brand new glass for less than $100
We got that and some black RTV sealant in the tubes like caulk (you use alot of this nasty crap) and got started.
The windshield seal is 2 pieces, we were worried when we took it out because we thought we'd ripped it but it's supposed to be 2.
Use a dull smooth screw driver to slide under the seal cut the sealant if you need, the dull screw driver is sharp enough to cut through the sealant but not the rubber seal so you can reuse it.
Once you have the old windshield out, clean everything up very well.
Next put the outside seal around the windshield with the seam at the bottom.
Grease the windshield frame where the windshield will sit with a liberal amount of the RTV sealant but be careful not to get much on the outside.
The next step takes at least 2 people, preferably 3. Take the windshield and carefully set it in the frame and then hold it in place while you or your partners get some straps and rolled up towels or somesuch.
You need to keep pressure on the windshield while the sealant dries. place the rolled up towels in the center of the windshield on both sides and then strap around the frame and over the pads to apply pressure.
Let it dry for a few hours and then fill the channel on the inside with sealant and install the inside rubber seal.
It's a messy job, have plenty of paper towels or rags handy and clean up any mess you make immediately, that crap is hard to remove when it dries.

crafty 08-21-2007 09:31 PM

This might not be a problem with a Texas jeep but---- Do you have rust in the windshield frame? Mine came from Maryland and that is the only rust it has. Right in the middle at the bottom, if it is you might need a frame also. Just a possible heads up;)


All times are GMT -5. The time now is 02:06 PM.