So I finally got all my gauges working. The only problem I have now is that my clock only works when the ignition is ON otherwise it just sits there dead and reads whatever time it was when I took the key out. I have read of a few people making "jumper" lines back on the printed circuit. My clock does WORK, but just getting it to work all the time again will be the trick.
08-20-2011 10:00 PM
You have it's power source on an acc wire. U need to find a constant hot wire to keep it going
08-20-2011 10:56 PM
The pink wire to the connector behind the printed circuit should feed the clock. That's hot all times, fed through the 20 amp 'dome' fuse under the dash.
08-21-2011 08:35 AM
If it doesn't rain, I'll go out and take a look at it today. Maybe take a few pictures.