Jeep Wrangler Forum

Jeep Wrangler Forum (
-   YJ Tech Forum (
-   -   Auxilary Lights (

bmxanrchy127 10-21-2011 02:26 PM

Auxilary Lights
I have 2 sets of auxilary driving lights( windsheild lights and bumper lights). Both sets of lights are wired up to a fuse and and a external switch. Its a pain to turn the lights on and off for each time you turn the high beams off and on so i was wondering if i could wire the bumper lights to the low beams and the windsheild lights to the high beams. Also i was wondering if i could still hook the sets of lights to a switch. (Bumper lights_switch 1-> low beams__windsheild lights_switch 2-> high beams)

Light switch 1-> off= wired to low beams_on= lights are one. Light switch 2-> off= wired to high beams_on= lights are on

Might be a little confusing but if anybody has any suggestions on how i could do this that would be great.

Peepers 10-21-2011 02:52 PM

I beleive you can hook two power sources up to the same relay. have the power from your switch and the power from your high beams / low beams connect to the switch side of the relay.

Xpress 10-21-2011 04:27 PM

How about wiring the bumper lights up so that when you hit the high beams, the bumper lights come on and increasing your visibility? That's low a lot of lighting systems on modern cars work nowadays, where there is a separate light for the highbeams that comes on when you flip on the highs. Then just wire up the windshield lights with a switch for offroad use.

All times are GMT -5. The time now is 04:32 AM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.